Dexter Single Hydraulic Jack Add-On w/ Selector Valve - 12,000 lbs

Video Transcript for Review of Premium - Dexter Trailer Jack - DX32CR

Hello, everybody. Steven here with etrailer.com. Today we're looking at our Dexter single hydraulic jack add-on with selector valve rated at 12,000 pounds capacity. Now folks, this is a add-on hydraulic jack leg to your existing hydraulic setup to lift your trailer quickly and safely. Now, the hydraulic pump and power unit would be sold separately. More likely than not, you would already have them though, and this would just be a simple add-on.

Now, this works with units offering up to 3,200 PSI extension and 1,500 PSI retraction. Now, this is gonna be ideal for use with livestock horse trailers as well as your commercial and construction trailers as well. As you can see, you get four hydraulic hoses included eight of these fittings. You get the nice selector valve to create a smooth and efficient operation even for heavy loads. And it's got all the ports on there and everything.

Very nice, heavy-duty, well-made. The square tube here is a 4 inch by 4 inch square tube with a durable exterior grade black finish. The foot plate is 9.5 by 9.5, and the jacket itself, when it's retracted like this, from the ground to the top, I got 30 3/4 inches. And extended, we got 50 3./4 inches fully extended. Now, up here on the front, you can see the two plugs there hopefully.

That's where your hydraulic hoses will connect. Now again, it says a lift capacity of 10,000 pounds, but a support capacity of 12. Now the maximum hydraulic flow rate with this is gonna be two gallons per minute. And once again, the maximum raising pressure is 3,200 PSI and the lowering is 1,500. So a nice little add-on kit here by Dexter.

Again, the single hydraulic jack add-on with the selector valve, the hoses and all the fittings. That's gonna wrap it up. I'm Steven. Thanks for watching and have a great day.