Reese Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 8-1/8" Long - 7.5K

Video Transcript for Review of Reese Trailer Hitch Ball Mount - Fixed Ball Mount - RP22AR

Hello, neighbor, Steve here with etrailer.com. Let's take a look at our Reese ball mount for two inch hitches rated at 7,500 pounds. So folks, this ball mount will let you hook up your trailer to your towed vehicle. The shank, again, two inch by two inches, gonna slide into your vehicle hitch's receiver tube, and both the drop and the rise options are available. So you can flip this over accordingly to get the rise or drop that you need for your specific towing needs. It is a heavy duty steel construction.

It's got a nice corrosion-resistant black powder coat finish and a ball would need to be purchased separately to complete this. And a hitch pin and clip is also sold separately to complete that. The ball hole would need to be a one inch diameter. And as far as some measurements, from the center of the hitch pin hole to the center of the hitch ball hole from there to there was 9-1/2 inches center to center. The rise on this, if you had it in the rise position from the top of the receiver tube up to the place where the ball goes would be 2-3/4 inches.

And if you have it in the drop from the top of the inside of the hitch opening down to the flat part here is four inches. And as you can see, they've got a nice gusset welded here on the backside that's gonna give it extra support and rigidity as it's rated at 7,500 pounds capacity. The tongue weight's rated at 750 pounds. And that's gonna ramp it up for our quick look at this Reese ball mount. I'm Steven, thanks for watching.

.