Curt Class III Ball Mount with 1-7/8" Ball - 4" Drop - 3,500 lbs

See what our Experts say about this CURT Trailer Hitch Ball Mount

• Is 1-7/8" Hitch Ball Available to Fit Curt 2-1/2" Weight Distribution Shank
  Hey Tony, thanks for reaching out! There aren't any 1-7/8" hitch balls that will fit the Curt Weight Distribution Shank # C17131 you're already using, but I do have a way you can tow your pig cooker by using the Curt Class III Ball Mount # C45055 along with the etrailer Magnetic Hitch Receiver Reducer Sleeve # e28JR. I know it's not exactly what you were hoping for, but the only alternative would be to purchase one of the adjustable tri-ball mounts that are a bit more costly than this setup.
  view full answer...
• How Much Rise Would Curt Ball Mount # C45055 Have
  The Curt ball mount # C45055 comes with a ball in the drop position, but if you were to remove the ball and flip it over to the rise position it would have a 2 inch rise.
  view full answer...
• What Drop Ball Mount is Needed for Hitch 22 inches from Ground and Coupler 16 inches From Ground
  Thanks for getting me the coupler and hitch height of your setup. Based on that you'd need a 6 inch drop ball mount. So for a 2 inch ball mount that has the correct amount of drop you'd want the # C45064 which comes with a 2 inch hitch ball installed as well as a hitch pin and clip.
  view full answer...
• Recommended Ball Mount with 1-7/8 Inch Diameter Hitch Ball for 2 Inch Trailer Hitch Receiver
  The 2018 Toyota 4Runner comes with a 2 inch hitch receiver that is commonly referred to as a Class III hitch. There are ball mounts that will allow for a 1-7/8 inch hitch ball that will fit your trailer hitch receiver. For the most adjustable option, I recommend the B&W Tow & Stow 3-Ball Mount # BWTS10048B which will give you the 3 standard hitch ball sizes and give you the ability to adjust vertically for your trailer coupler height to tow level. It also has a nice stowable feature...
  view full answer...
• Hitch for Small Truck
  I have several hitches that closely match what you are looking for. Hitches I have that fit a 2"X2" receiver opening, and with 4" drop are as follows. Curt # C45055, 8-1/4" hitch pin center to ball mount center. Overall length is 12-1/2" Curt # C93KR, 8-1/4" hitch pin center to ball mount center. Draw-Tite # 40331, 9-3/4" from hitch pin center to ball mount center Curt # C45313, 10" from hitch pin center to ball mount center Draw-Tite # 4285, 12" hitch pin center to ball mount center....
  view full answer...
• Flipping The Curt Curt Class III Ball Mount Upside Down For A 2" Rise
  Yes you will be able to flip the # C45055 upside down and also flip the hitch ball around to create a 2" rise.
  view full answer...

Do you have a question about this Trailer Hitch Ball Mount?