Ideal for bolt-on applications, this butt hinge with a 1/4" pin and 3 mounting holes on each side replaces the worn-out or damaged hinge on your cabinet, door, or panel. Mounting holes are countersunk to eliminate interference when closing.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi there, I'm Michael with etrailer.com, today we're going to take a quick look at this three hole stainless steel butt hinge. This is a three inch wide by three inch tall, very durable stainless steel hinge on that is going to resist erosion thanks to that stainless steel construction, this will provide a nice, sturdy support for your cabinet, door or panel, and this will be great for either commercial or residential use because it is going to be so durable and strong. It does have a 2B mill finish. It's going to give the metal, a nice bright shine, very simple to get installed at the bolt-on installation with the three 3/16th inch diameter holes on each side. And those holes are pre-drilled and they have that counter sink design to help eliminate any interference when you're closing the hinge, your screw heads aren't going to stick up. They're going to be nice and recessed there so that you're going to have plenty of range of motion to make sure that everything is closing properly.
Our hole spacing from the center of our outside holes, we'll go to the backside here so it's a little easier to see, from the center to the center, it is right about two and three eights of an inch. Our inner hole center to center is approximately one and 3/16ths of an inch. And then that hole is set in approximately one quarter of an inch, so make sure that's going to work for your mounting pattern, but this does rotate 270 degrees around the quarter inch diameter tight pin. So it's going to give you full range of motion here, it's going to be a great option for you if you are looking for a hinge. This is the knuckle length here is right at three quarters of an inch, and you can see we've got those two knuckles can make sure that we have a nice sturdy connection around that pin.
This is made here in the USA, so you can trust it's made to the high quality standards that we've come to know and trust for products that are made here in the US. So if you are looking for a three inch by three inch three hole hinge, this is going to be a great option for you. That's going to complete our look for today. Again, I'm Michael with etrailer.com. Thanks for watching..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.