2" Wide Continuous Hinge - 6' Long - 1/4" Pin Diameter - Stainless Steel

Video Transcript for Review of Marlboro Trailer Door Hinges - Barrel Hinge - MA54ZR

Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this 72 inch long, two inch wide stainless steel piano hinge. Now, this hinge would provide sturdy, continuous support along the length of your cabinet, your door, or your panel. It's great for oversized doors, trailer doors, and entrance doors. And this will provide more support than multiple small hinges.

It is a nice continuous design, so it does reduce stress on the hinge when used with heavier doors. And this does rotate 270 degree, 270 degrees. Just want to zoom in and show you what we're talking about. So, you can see this part will fold back about 90 degrees. And then if you fold it the other way, it'll go about 180 degrees more.

So, it's about 270 degrees total revolution or rotation. Gives you a nice full opening and closing motion. And this is made of a durable stainless steel construction, which will resist corrosion. Does use a 2B mill finish, which gives the metal a bright shine. It's a standard finish that's nice, smooth, bright and moderately reflective, and may exhibit a slight luster.

Now, to install this in, it is a weld-on or bolt-on installation. Now, if you do bolt it on, it does require drilling holes into the hinge. This part is made in the USA. Few specs on this, we'll start with the overall length. So, we'll take our tape measure, go from one end, all the way to the other end, right at 72 inches or six feet.

The width on it when we have it all fully in, in the open position you can see, so the width, that position is gonna be right at two inches. And the knuckle length, each one of these partial portions here is called a knuckle. So, if we do the length of each knuckle is gonna be, you can see right at one inch. And the pin diameter, in other words, the long pin that goes through those knuckles that hold these two pieces together, diameter of that pin is gonna be right at a quarter of an inch. Again, you can see how it folds 270 degrees. But that should do it for the review on this 72 inch long by two inch wide stainless steel piano hinge..