Titan Hydraulic Brake Kit - Uni-Servo - 10" - Left and Right Hand Assemblies - 3,750 lbs

Video Transcript for Titan Trailer Brakes - Hydraulic Drum Brakes - T1878800-700 Review

Speaker 1: Today we're taking a look at the Titan hydraulic brake kit. These are 10 inch, uni servo brake assemblies. The uni servo design is a single plunger design that helps to deliver around 20 percent braking in reverse. The hydraulic drum brake assemblies are designed for use with a surge type trailer brake actuator. They do feature the black paint finish on the back plate. And they are labeled right and left hand side for easier installation, you know exactly what side of the trailer they're supposed to go on.Each assembly can be manually adjusted as needed using the adjuster knob at the bottom.

The pads on the unit are fully bonded, not riveted to the shoes, for longer life and more breaking torque. And then the adjuster plugs are included. These are the rubber plugs that cover the access holes to help keep dirt and grime out of the assemblies and off the shoes.With this part number, you do get the both the left hand, or driver's side, brake assembly, and the right hand, or passenger's side, brake assembly. Mounting bolts and hardware are sold separately. When it comes to the measurements, we're looking at a 10 inch diameter.

So to get that measurement, what we do is we basically measure outside edge of one pad to the outside edge of the other pad. So if we put a ruler on there and measure straight across, that's where we get the 10 inch measurement. And then they measure two and one quarter inch wide, and that's the width of the pad right here on the shoe.This assembly's designed to work with wheel sizes 13 inch, 14 inch, or 15 inch. The mounting flange bolt pattern, that's a four bolt design. Th center hole has a diameter of three inches, and these are designed for axles that have a rating up to 3,750 pounds.That's gonna do it for today's look at the Titan hydraulic brake kit..