To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
These strong, galvanized steel crossbars supply the backbone for this Yakima roof rack. The rack works with accessories that clamp around the bars. Vinyl coating helps resist corrosion. Installs on your vehicle's naked roof.
Features:
Specs:
Alternate Instructions
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, on our 2008 Toyota Highlander, we're going to be test fitting the Yakima Q Towers Roof Rack System, part number Y00409, Y00124, and Y00699. With our Q clips, Q towers and round bars assembled according to the included instructions, we'll begin our test fit by first opening the front passenger and driver's side door. With that done, we'll go ahead and place the front bar onto the front of our roof. We'll need to measure 9 inches from the front part of the glass to the first part of our tower. We're going to make this measurement on both the passenger and driver's side of the vehicle. This will ensure that the front bar is perpendicular to the roof, and the pads on the underside of the Q tower and clips, contour to the roof line correctly. Once this is done, we can lift up on the black cover to tighten down the silver hand bolt on the inside of the tower.
We'll tighten down each side a little bit at a time, and then clamp down the lever, which will bring the clip up tightly against the roof line. With the front bar secure, we'll go ahead and close the doors, and open up the rear set of doors. We'll place our rear bar onto the rear of our roof. With the rear bar in place, we can lift up the black covers, and tighten up the silver hand bolt on the inside of the tower. Again, we'll tighten each side, a little bit at a time, and then clamp them down, making sure the bar stays centered. Once everything is all tightened down and secured, that will complete today's test fit of the Yakima Q Towers Roof Rack System, using part numbers Y00409, Y00124, and two of the Y00699's on our 2008 Toyota Highlander.
.
So far so good! Cant beat the price!
Do you have a question about this Roof Rack?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.