Kwikee RV and Camper Steps
- LC3722616
- 2 Steps
- Electric Step
- Motorhome
- 24 Inch Wide Step
- Kwikee
- 25-1/4 Inch Wide
- Steel
- 8 Inch Drop/Rise
- No Ground Contact
Replaces the electric steps and motor that work with your existing Kwikee control unit and switch kit. Control unit (sold separately) or switch kit (sold separately) is required for operation.
Features:
- Replaces the steps and motor for your Kwikee 32 series RV steps
- Control unit or switch kit is required for the steps to extend and retract
- Control unit for automatic extension
- Switch kit for manual extension
- Motor features a fully-sealed gearbox with brass ball bearings and linkage
- Non-slip tread and easy-to-see reflective strips on step surface
- Sturdy, powder coated steel construction with weatherproof wiring withstands the elements
- Solid steel drive rods and stainless steel bushings provide additional durability
- Air pressed rivets at pivot points ensure long-term strength
- Simple installation with existing mounting holes and wiring harness
- Made in the USA
Specs:
- Extended height: 14-1/8"
- Overall width: 25-1/2"
- Mounting plate dimensions: 23-3/4" wide x 11-3/8" deep
- Bolt pattern: 22" wide x 8" deep
- Step dimensions: 24" wide x 11-1/8" deep
- Drop/Rise: 8"
- Voltage: 12V
- Weight capacity: 300 lbs
- 1-Year warranty
Note: This step assembly includes the step and motor only. For the steps to work, you will need either a control unit, a switch kit, or both.
If you want the complete step assembly that allows the steps to automatically extend and retract with the RV door, you will need a control unit (sold separately). You will also need a switch kit (sold separately), which lets you override the automatic retraction, so the steps stay out whether the door is open or closed. The complete assembly with steps, motor, control unit, and switch kit is available under part number LC372261.
The included 4-way plug fits into the existing wiring harness on your RV. Most vehicles should having this wiring already set up. In the event that your RV is missing the wiring, a 4-way pigtail is included to help you hardwire the unit to your RV.
Safety Features
The Kwikee steps include several safety features in an effort to prevent injury to you or your passengers and damage to the RV steps. If an obstruction is detected while extending, the steps will halt and retract back into the stowed position. The steps will also retract when you turn on the vehicles ignition, even if the automatic retraction override has been activated, in case you forget to stow them before driving away.
Will Kwikee Electric Steps Work for You?
Electric steps are typically installed on RVs and some travel trailers. The electric steps from Kwikee install and fold up underneath the camper for simple storage. To ensure you choose the correct size for your application, there are a few measurements you will need to take.
![Kwikee In and Out]()
The Kwikee electric steps attach to the underside of the camper chassis, directly beneath the doorway. To decide which size you'll need, locate the space available underneath your camper that lines up with the doorframe, and measure the width and depth. You will need a mounting space that is at least 25-1/2" wide and 11-3/8" deep.
If it turns out you have more or less space beneath your doorway, there are other step assemblies available with bracket sizes ranging from 24-3/4" wide to 37-1/4" wide. A full list of the available steps is below.
![Outriggers for RV Steps]()
Outriggers - metal brackets that act as an extension (LC301704 - sold separately) - may be needed for installation depending on the model of your original stairs. These provide extra length if the old steps are longer or wider than the new.
Once you know where the mounting bracket will go and what size mounting bracket you need, that spot will be used as the "mounting point" to determine how many steps you will need.
How Many Steps Do You Need?
![Kwikee Entry Height]()
To decide on how many steps you'll need, measure from the mounting point to the ground. This is called the entry height. The entry height should roughly match the height of the steps when they're fully extended, plus 6" to 8" to account for the drop from the bottom step to the ground. This measurement will also tell you how many steps you need.
The chart below displays mounting bracket widths in the first column and entry height measurements in the second column. The third column shows the corresponding part numbers. Use the mounting bracket width and entry height measurements you took to determine which part number will fit your RV. Choose the bracket size that is closest to your measurements without going over.
This page's step assembly is in bold text.
Mounting Bracket Width | Entry Height | Part Number (Complete Assembly) | Part Number (Replacement Assembly) |
---|
24-3/4" | 15-5/8" - 17-5/8" | LC3747453 | LC3747452*, LC3747451** |
25" | 16-3/4" - 18-3/4" | LC3724742 | n/a |
25-1/2" | 27-7/8" - 29-7/8" | LC3658373 | LC369552*, LC365837* |
25-1/2" | 20-1/8" - 22-1/8" | LC372261 | LC3722615*, LC3722617**, LC3722616*** |
25-1/2" | 20-1/2" - 22-1/2" | n/a | LC3725791* |
25-1/2" | 12-1/8" - 14-1/8" | LC3723383 | LC372338** |
25-1/4" | 13" - 15" | LC3711363 | LC371136*, LC3711361** |
25-3/4" | 22-7/8" - 24-7/8" | n/a | LC372558* |
25-5/8" | 11-7/8" - 13-7/8" | LC3691461 | LC369146*, LC3691462** |
25-5/8" | 13" - 15" | n/a | LC3726041* |
25-7/8" | 23-1/4" - 25-1/4" | LC3726892 | LC3726891** |
26-5/16" | 27-1/4" - 29-1/4" | LC3694042 | n/a |
29-3/8" | 18" - 20" | LC3722661 | LC372266*, LC3722662** |
30-1/4" | 15-1/4" - 17-1/4" | n/a | LC372779* |
30-3/8" | 17-1/4" - 19-1/4" | n/a | LC427247* |
30-5/8" | 20-1/2" - 22-1/2" | n/a | LC375632* |
31-1/2" | 28-5/8" - 30-5/8" | n/a | LC375821* |
31-1/2" | 12-3/8" - 14-3/8" | LC3756271 | LC3756272** |
32-3/8" | 20-1/4" - 22-1/4" | LC3722862 | LC3722863** |
37-1/4" | 18" - 20" | n/a | LC3694112*, LC369411*** |
*Motor and control unit
**Motor and switch kit
***Motor only
How Do You Install the Steps?
To install the steps:
- Hook up the steps to power to verify that all components are in working order
- Make sure the camper is level on flat ground
- Lift the steps into the mounting space and prop into place
- If needed, mark the mounting holes on the camper and drill
-Set aside steps before drilling
- If needed, install the outriggers
- Align step mounting holes and secure in place with carriage bots and flange lock nuts
-Make sure bracket is backed up fully against the I-beam on the chassis
-Hardware not included
- Tighten hardware until snug
- Make sure assembly is sitting square and level
- Torque the hardware tight
- Connect the appropriate writing to your vehicle's source
3722616 Lippert Components (LCI) Quickie 32 Series Motorized Motorhome Entry Steps - 2 Stairs - 8" Drop/Rise - 24" Wide - 300 lbs
Kwikee Part Number 903200900
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.