JR Products gas shock replaces 1 worn or damaged shock on your RV entry door or storage doors. Durable black-nitride finished gas shock measures 9.66" compressed, 17" extended, and has 60 lbs of force.
Features:
Specs:
When replacing gas shock on your vehicle or RV, you will want to make sure you are buying a replacement with the exact same extended length, compressed length, and pounds of force. This information is usually printed on the shock. Lengths are measured from the center of the ball joint used for mounting. If you are planning on installing gas shocks on something for the first time, identifying the shock you need requires fairly complex initial calculations, so be sure to do your research to avoid purchasing a shock that will not fit your application.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to take a look at the JR Products 17-inch long gas shock. Now, this gas shock is designed to replace a worn or damaged shock on your RV entry door or storage doors. The extended length on this shock is measured from the center of this ball socket to the center of this ball socket. So, if we put a tape measure on that, it's 17 inches for the extended length. If we compress this shock, then the length would be 9.66 inches. Output force on this is 60 pounds.
And the connection type on each end is a retaining clip on a 10-millimeter ball socket.I want to zoom in just to describe that to you and tell you how it installs, but basically on each end, you'll see the ball socket right here is designed to fit onto a 10-millimeter diameter ball. And basically, the way you install it is on top is this retaining clip. You just slide a flat tip screwdriver underneath the clip, pry up on it, and it'll pop loose. And then that'll release the pressure on the socket there. And then you'll be able to push this onto your 10-millimeter ball.
Once it's on there, then push that clip back down, and it secures it in place. Very simple installation.This shock also has a nice black nitride finish to it, but that should do it for the review on the JR Products 17-inch long gas shock..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.