MB Sturgis Propane Hose - 3/8" Male NPT x 1/2" Female Flare Swivel - 4'

See what our Experts say about this MB Sturgis Propane Fittings

• Propane Hose Replacement For 18CE Cavagna Group Recommendation
  Searching by part number it appears the MB Sturgis Propane Hose Assembly # 100383-48-MBS would be the replacemement part you need for at least the 18CE Cavagna Group replacement. The picture received on our end was a duplicate and you mention there's a different connector for it so if there is a different label for the second connector I would be happy to check that one as well. Regarding braided vs. rubber line durability, the braided stainless steel can protects the thermoplastic...
  view full answer...
  
• Recommended Hoses and Regulator to Connect 100 Pound Cylinder to Main House Line
  It sounds like you are needing a hose and regulator to go from your 100 pound cylinder to the house main line. If you have a DOT tank with a Type 1 fitting, you can use a hose like the MB Sturgis Propane Pigtail # 100833-15, which can connect to a regulator like # 108220. From there you can connect a hose assembly like the 4 foot # 100383-48-MBS if your main line uses a 1/2 inch flare fitting. You can also install the Camco Propane Cylinder Gas Gauge # CAM59023 to the tank before the...
  view full answer...
• 12 Foot Long Propane Hose to Connect BBQ to Disposable Cylinder Fitting
  The large port on your Extend a Stay, basically part # CAM59113, is a male 1 - 20 disposable cylinder connection. To hook your BBQ grille up using that fitting you can use part # 204132-MBS which is an adapter to a Type 1 fitting. Then use a Type 1 hose with a regulator, like part # CAM57721, that's 12 feet long and has a 3/8 female flare to connect to the grill. If these parts don't have the correct fittings let me know.
  view full answer...
  
• Replacement Regulator and Pigtail Hose for Champion 3500 Dual Generator Model 100264
  We do have a hose and regulator that you can use on your Champion 3500 Dual Fuel Generator model # 100264. You can use the Camco Automatic Changeover 2-Stage Propane Regulator # CAM59005, which is a direct replacement for the regulator on your generator. For a LP hose I recommend using the Camco Propane Supply Hose # CAM59153 which has the male inverted flare that will fit that regulator and run to your propane supply. If you need a hose to run from the regulator to the generator, you'll...
  view full answer...
• Dual Propane LP Tank Setup 100 Lb for RV or Travel Trailer
  Yes, the # 100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the # 204120-MBS fitting that includes a back-check. Without the back-check, your setup would not be RVIA (Recreation Vehicle Industry Association) compliant. You mentioned that you'd like to connect to a T first, before connecting to the regulator. I called my contact at MB Sturgis to...
  view full answer...
  
• Solution for Needing 4-1/2 ft Long Propane 1/2 inch Diameter Feed Hose
  We have a 4 foot section of 1/2 inch propane hose with part # 100383-48-MBS and we also have a 5 foot section with part # 37207-31475 but we do not have a 4-1/2 foot long section.
  view full answer...
• Recommendation For 3/8 Inch Female Flare Swivel x 3/8 Inch MPT Propane Hose
  I believe we have exactly what you need. I recommend the MB Sturgis High Pressure Propane Hose, Item # 100040-72-MBS. This propane hose has a 3/8 inch male MPT on one end and 3/8 inch female flare swivel on the other. It is 6 foot long and has a maximum pressure rating of 350 psi. I have attached additional information and a video for you to check out.
  view full answer...
• Determining Replacement Supply Line From Regulator To Steel Line On Camping Travel Trailer
  While I cannot say exactly what supply hose you need coming out of your Regulator # 37207-31525, I can help you to determine which hose you will need. Typically you will find a hose like the Supply Hose # 100383-48-MBS coming out of the regulator and down to the solid steel pipe under the trailer. You will need to verify the regulator side has a 3/8" MPT fitting and the steel pipe side is 1/2" FPT. This particular hose is 4' long. If you find you have different connectors or a different...
  view full answer...
• Replacement Regulator and Hose for 1992 Marshall M 260
  Thanks for the pictures! I have a better option for your setup based. It is the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr item # CAM59333. The Camco will work as a replacement for your Marshall 260 Horizontal LP regulator and it includes a P.O.L. connector. It has a 3/8" NPT inlet connector so you will need the MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' item # 100383-48-MBS.
  view full answer...
  
• Propane Hose to Connect Trailer's Propane System to Regulator
  Thank you for the photo and from that it looks like you have a 1/2 inch fitting, which is common for the hose coming from the propane system on your trailer. However, there are not extensions with a 1/2 inch fitting so we have replacement hoses of different lengths though you'll need to determine if they are the proper length for your needs. - MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 3 Feet # 100383-36-MBS - MB Sturgis Propane Hose Assembly - 1/2" Female...
  view full answer...
  
• Hoses Needed to Install MB Sturgis Vertical 2-Stage Propane Regulator
  Thanks for reaching out, Tara! In order to connect the MB Sturgis Vertical 2-Stage Propane Regulator # 108220 to your propane tank and your 2018 Zinger Lite you'll need the following hoses: - Pigtail # 100473-24-MBS (from tank to regulator) - Hose # 100383-48-MBS (this is 4' length but we have longer if needed) Please note you'll need the Thread Sealant Tape # 37207-30025 for both connections on the regulator.
  view full answer...
• Recommended Propane Hose that Runs from Regulator to RV
  It sounds like you are just needing a hose assembly like the MB Sturgis Propane Hose # 100383-48-MBS. This 4 foot long hose is designed to connect a 2-stage regulator to the RV's propane system. It features a 3/8 inch Male NPT at one end that will connect to the regulator and then a 1/2 inch Female Flare Swivel that will connect to your RV. You will just want to verify the type of connection you need on the RV end. Another common connection is a 3/8 inch female flare swivel. If this is...
  view full answer...
• Parts Needed to Connect Manchester 10 lb Propane Tank to 4 Propane Cookers on Food Trailer
  From what I can tell it looks like you need the adapter # 204037-MBS, regulator # 108221, and hose # 100383-48-MBS for your propane setup. I'm not sure what the POL to QCC1 converter is that you mentioned but these parts get you from the POL connector on your Manchester 100 lb propane tank to the 1/2" flared fitting that I believe your picture shows goes to your 4 propane cookers. If you have something else please let me know. I have attached a photo showing how these parts are typically...
  view full answer...
  
• Hose For Camco Horizontal 2-Stage Propane Regulator w/ P.O.L CAM59333
  The hose is going to depend on what you are using the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr # CAM59333 with. It has a POL fitting for the tank, and for the hose, one end will be 3/8" Male NPT to connect to the regulator, and the other end will depend on the fitting you need for your appliance. For example if you needed a 1/2 Inch - Female Flare fitting you could use the MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel - 4' # 100383-48-MBS. I...
  view full answer...
• Parts Needed to Connect 100 Lb Propane Tank to Water Heater
  It sounds like what you need is a pigtail to go from the tank to a regulator, then from the regulator you'll need a supply hose that's long enough to reach and connect to the to inlet valve (manifold) on your food truck and that has the correct fitting. Below are the parts I recommend: 1. MB Sturgis Propane Pigtail - Stainless Overbraid - Type 1 x 1/4" Male Inverted Flare - 1' # 100833-12 2. MB Sturgis Vertical 2-Stage Propane Regulator - 11" Water Column Outlet # 108220 3. MB Sturgis...
  view full answer...
  
• What Is The Actual Inner Diameter Of The MB Stugis Hose # 100383-48-MBS
  The inner diameter of the MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4 foot # 100383-48-MBS is 3/8 inch.
  view full answer...
• What Type of Fitting Matches my Propane Hose
  The fitting you have described matches the measurements I see on the 1/2" female flare like the one on the MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' part # 100383-48-MBS or the 3' part # 100383-36-MBS. Check out the video my buddy Ellen did on the hose it is linked for you.
  view full answer...
• Is Teflon Tape Needed On Either End Of Sturgis Propane Hose # 100383-48-MBS
  When connecting hoses like the Sturgis Propane Hose # 100383-48-MBS, The 1/2 inch flare swivel fitting does not need any Teflon tape or sealant. Teflon tape or sealant can be used on pipe fittings like the 3/8 MPT on the opposite end
  view full answer...
• Parts Needed to Hook Up to 100 lb Propane Tank on 2019 Grand Design Transcend RV
  From what you described it sounds like you're needing the T-Fitting # 103602-MBS along with the Fill Hose # 100019-144 (for your small tank), the Tank Connector # 204037-MBS, and the 2-Stage Propane Regulator # 108221. Attached is a photo of what this setup looks like and below is a full list of the parts you'll need if all you currently have is the 100 lb tank: T-Fitting - # 103602-MBS Fill Hose - # 100019-144 Adapter Hose - # 100284-144-MBS (for an appliance like the Grill # FR51322) Tank...
  view full answer...
  
• Propane Regulator for a 100 lb. Propane Tank to Run Two 70,000 Btu Fryers
  For your 100 lb. propane tank you can use the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L # CAM59333. This regulator is rated for 160,000 Btu/hr and has the P.O.L. fitting to hook directly up to your tank. You would then need a hose to run from the regulator to your supply line. Since you mentioned 1/2", a hose like the MB Sturgis Propane Adapter Hose # 100383-48-MBS has a 3/8" fitting to fit in the regulator and a 1/2" female flare swivel on the other end.
  view full answer...
• Replacement For Marshall Gas Flexible Hose Model A6 Part Number 42611-48
  Yep, I sure can; the Marshall Gas Flexible Hose Model A6 part 42611-48 is a high pressure 48 inch hose with 1/2" female flare and 3/8" MPT fittings. You can replace the hose with one from MB Sturgis: - MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' # 100383-48-MBS
  view full answer...
• Extension Hose for Dual Propane Tanks After Regulator on RV
  We have a large selection of propane extension hoses which I have attached for you. In order to find the correct one we would need to know what type of fittings you need on either end. If you do not know what type of fittings you need then you will want to take a look at the attached help article which explains all of the different types. The back check valve you are referring to is usually built into the leader hose that connects the tank to the regulator so you do not need an additional...
  view full answer...
• Replacement Propane Supply Hose From Regulator to RV Propane Supply Line
  It sounds like you're looking for a 3 foot long supply hose; typically the outlet end of a regulator will almost certainly be a 3/8" female NPT and from the picture you sent it looks like you've got a female flare connector on the other end that goes to the metal RV piping. Additionally, since you've said that the piping side is larger it sounds like you're looking for the # 37207-31445 which has a 1/2" Female flare connector on one end and a 3/8" male NPT on the other.
  view full answer...
  
• How to Correctly Measure a Propane Hose
  In order to correctly measure a propane hose you will need to measure end to end (fitting to fitting). The propane hoses we sell are by the foot so this may make it easier to determine what you need. It is also a good idea to get a hose that is a bit longer than what you need to account for any errors during measuring. For example, the MB Sturgis Propane Hose Assembly part # 100383-48-MBS is 4' long end to end. I have attached a list of our propane selection for you as well.
  view full answer...

Do you have a question about this Propane Fitting?