NOCO Genius Boost HD Jump Starter - LED Work Light - USB Port - 12V - 2,000 Amp

Video Transcript for NOCO Genius Jumper Cables and Starters - Jumper Box - 329-GB70 Review

Speaker 1: Today, we're gonna take a look at the NOCO Genius Boost heavy duty, 2000 amp, ultra safe lithium jump starter. Now this part will include everything shown here on the table, the jump starter with these integrated, heavy duty battery clamps, micro USB cable for charging this through a USB port. Also has the XGC 12 volt male adapter, XGC 12 volt female adapter, XGC extension cable, nice user's guide, and a really nice microfiber storage bag for keeping everything in one location. This has a nice portable handheld design. It's over four times smaller, four times lighter than your traditional battery booster pack. So it only weighs about five pounds.

It's great for storing in your glove compartments, center consul, trunk, or your tool box. Now this is a multi function jump starter and USB device charger. It's designed for jump starting cars, truck, boats, and RVs and it can also be used right over here if you pop the port open. It has a USB port.So it can be used to recharge your USB devices like your smart phones, tablets, and more. It has the USB output, which is about 2.1 amps.

It is also designed to power 12 volt devices, like a tire inflator, power inverter and much more using the XGC output right here, which is about 15 amps. Now to charge the jump starter, you can use the micro USB port on the side here. It's a 2.1 amp and you just use the micro USB cable it comes with. It takes about seven hours to a full charge. Now you can actually do a faster charge using right next it the XGC port.

It's about three amps, takes only about two hours using your XGC system. It'll provide up to 40 jump starts with a single charge. It's rated for over 1,000 charge cycles and it holds the charge level for over a year with minimal power loss.Now the battery cables, they're heavy duty integrated battery booster clamps that will reach most battery post or chassis ground and they offer spark proof technology, which means usually when you're jump starting something, if your cables happen to touch each other, they'll spark. In this case, they won't do that. Now they are make with a high temperature silicone wire insulation, remains flexible down to negative 40 degrees fahrenheit and will withstand exposure to high temperatures.

Has a power button right here, allows you to turn on and off the jump starter. We're gonna do that. Let's zoom in so I can give you a closer view of it and show you what the button and lights will mean. Right here is your power button. So you just push that one and right over here, you'll see a power light come on and then it has the LED indicators right here. This will display your charge level, charge status and any errors. The charge level LEDs will give you a visual to the amount of charge on the battery. So right now, if you look at it, it'll show three buttons lit. So that's telling me 75%.Each separate LED, the first one is 25%. Second one is 50%. Third is 75% and the bigger fourth one would mean it's 100% charged. Does have an error LED right here before the other chare level LEDs. This error level is when you're connected in reverse inaudible 00:03:08 disables for thermal protection. The boost LED, which is the button right here, this will illuminate when you're properly connected to the battery. It does have a manual override button, this red button highlighted right here. This will alow you to jumpstart a battery below two volts. This button here, if you push it, hold it for about five second, that'll turn on the boost jumpstart function and you can see it's flashing there and then if you have a mostly dead battery, it'll allow you to give you a boost jump and then to turn it off, just push that button again. It does have a rechargeable eight LED flashlight right here on the end. It's great for working on your engine, changing a tire at night or warning traffic while waiting for roadside assistance. This LED flashlight output is about 400 lumens.I'm gonna show you how the light mode works. It gives you seven different light modes. We're gonna go ahead and turn off the overhead lights and I'll turn it on. Now when you do operate this, here's your light button. It shows a light bulb here. When you want to change modes, you push it each time. But you need to do it within three seconds to change the mode. If you wait longer than three seconds, it'll just stay on that last mode and then if you push it again, it'll turn it off. So I'm gonna turn off the overhead lights and try to show the seven different modes. First three are gonna be the luminosity settings of how bright the light is. So we'll turn that off. Go ahead and turn that on. There's your 100%, 50%, 10% and hit it again. There's an SOS. Hit it again. There's a blink. Hit it again. There's your strobe and you can see it's very bright and then you hit it again. It's off. So again, you do that within three seconds. You go through all the modes.If you wait longer than three seconds, the last one is what it'll stay on. Does have a built in energy saving feature, which will automatically turn the unit off after seven hours. Starting current on this is 2000 amps peak. Battery types it charges is 12 volt lead acid batteries. Internal battery in this is a 55 watt hour lithium ion batter and just to give you a dimension, oh. Turned the light on accidentally. Turn it off. We'll go ahead and turn the power off. I'm gonna zoom out a little bit here. There we go. There's your charging cables you can see here. Overall dimension on the unit itself, overall length is gonna be right at about 8 1/4" long. The width on it is right about 3 7/8" and the overall height is about 2 1/2". What I do want to do is just show you a few of the features. Again, here's your, on this end here, here's your USB port if you want to charge any device.Now the out, if you take your cable here and you plug in your XGC cable and then on the other end, you can plug it into this one and then there's your 12 volt out. So you can put any 12 volt, control any 12 volt device through that. If you do it the other way, let's show you the other port here. They have nice sealing caps to keep any . On this one, it's the in. It'll also have the USB. So you just plug your micro USB in there to charge it. But if you want a faster charge, you can take your cable again, plug in the other side and then using the other end, plug it into this one and that'll plug into your 12 volt port in your car. So you could charge this a lot faster using the XGC system. Very nice system they have here. Then we'll go ahead and put that cap back on there just like that. Then we'll go ahead and store our cables. All you have to do is they grip right onto the side there and you have a nice portable jump starter.But that should do it for the review on the NOCO Genius Boost heavy duty, 2000 amp, ultra safe, lithium jump starter.