Smart converter charger extends RV battery by fighting sulfation during storage. Multistage charging process switches modes to ensure a quick, complete charge. Converts AC shore power to DC power to run 24V loads at the campground.
Features:
Specs:
This smart converter charger converts AC shore power into DC power and uses the Charge Wizard multistage charging system to charge your battery bank. If your RV already has a stock converter charger, it will need to be removed to ensure this unit operates properly.
Using the built-in Charge Wizard, the converter charger automatically switches voltages while the battery bank charges. This accelerates the charge, but also helps extend battery life by adjusting the voltage during the different modes. This charger is compatible with flooded lead acid, AGM, and gel batteries.
Charging Modes
The system includes a number of safety features. It has a reverse polarity protection that will protect the converter if the battery is hooked up incorrectly. Additionally, the unit includes protection for overvoltage, undervoltage, and overcurrent, which can damage your equipment, as well as the converter. It also has GFCI protection that shuts off power when there is a current imbalance. The built-in cooling fan also removes excess heat from the unit. The fan speed is proportional to the internal temperature on the converter, so when the power demand is low, the fan will operate quietly.
The Converter Status Remote Pendant (sold separately) monitors the converter's charging status. It also allows you to manually override the charge process to verify the unit is operating properly. The pendant uses a flashing green LED to indicate what charging mode is active. It easily connects to the converter's accessory port with the attached cable.
The converter mounts horizontally inside your RV in a dry location with ventilation. However, as long as the unit has sufficient ventilation, it can also be mounted vertically. The mounting hardware is not included.
The DC output terminals wire to the battery bank. The AC in cord plugs into a 120V 3-wire grounded source.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to take a look at the Progressive Dynamics PD9200 series, 24 volt, 25 amp, Intelipower Converter Charger. Now, this Power Converter Charger will deliver DC power to and charges 24 volt batteries for specialty vehicles and stationary application. It is perfect for buses, local refrigerated delivery trucks, emergency vehicles, communication trucks, over-the-road trucks that have sleeper cabs, and even for solar energy. It does use a built-in charge whizzer, which is a four stage charging system, constantly monitors the Batteries, and it automatically adjusts your converter output voltage based on the battery's charged status. This Converter Charger is capable of charging multiple batteries at the same time and it can also charge different capacity batteries at one time.Does have built-in features to ensure long-term reliability. Has electronic current limiting, which automatically reduce the output voltage to prevent overheating.
Has reverse battery protection, prevents the charger damage if connections are accidentally reversed. Has high voltage and low voltage protection to prevent damage from AC input voltage fluctuation. Does use automatic thermal protection to protect from damage due to excessive heat. Over here, if you notice, it does have a variable speed, intelligent cooling fan, which will only operate under high heat conditions. This is GFCI protected.
Helps prevent ground fault interruption.If you notice right here on the front, you'll see this little plug here. This is a built-in accessory port, makes it easy to add the converter status remote pendant. That'll show which mode the converter is operating in.This part is assembled in the USA. Few specs on this. The input voltage is 105 to 130 volts AC.
The wattage is 900 watts. Output voltage is 27.2 volts DC. Power draw is 25 amps. Want to give you a few dimensions on this. Now, we're going to measure the length of it.
We're going to measure from this end, all the way to where the fan sticks out. If we put a ruler on that, you'll see it's right at eight and a quarter inches long. Total width on it, we're going to measure down by where the mounting brackets are. Right all the way across, it's seven and a quarter inches wide. Your total height on this is going to be right at four and a half inches tall. Now, the power cord on this is 30 inches long, and the weight of this unit is only about four and a half pounds. That should do it on the review on the Progressive Dynamics PD9200 Series, 24 volt, 25 amp, and Intelipower Converter Charger.
Do you have a question about this RV Power Converter?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.