Powder coated, carbon steel tube welds to your cab and chassis truck to give you a 2" receiver for towing. Can be cut and customized to act as the center section of your fabricated hitch.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we are going to take a look at the 18 inch long, two inch by two inch black weld on receive tube. These weld on receiver tubes are available in a variety of lengths, dimensions and finishes to match your towing needs. This part happens to be the 18 inch long version. This is a two inch by two inch receiver tube. The internal dimensions are two inches by two inches. It features a nice cast steel collar and a solid stress collar opening.
This 18 long finished tube contains a five-eighths inch hitch pin hole. Five-eighths inch diameter hitch pin hole and it can achieve a rating up to 20,000 pounds. It's a nice carbon steel construction. It has a black powder coat finish. It is open all the way through.
It's open on both ends and then just to measure this we go from this end to this end, is right at 18 inches long. Again, the maximum gross trailer weight capacity on this is 20,000 pounds.That should do it for the review on the 18 inch long, two inch by two inch black weld on receiver tube.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.