Show your support for our country's imprisoned or missing servicemen and women with this hitch receiver cover. The POW/MIA flag is outlined in chrome-plated ABS plastic and mounted on a rustproof, polished stainless steel base.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at part number AUT-POW-C. This is the POW/MIA flag trailer hitch cover for two-inch hitches. The unit's going to slide into your hitch receiver to help keep out dirt and prevent rust. It's also going to add a nice, clean, finished look to your hitch. We're going to have the black and white decal, that's going to be outlined in a chrome plated ABS plastic construction. Then on the internal part right here, we're going to have a nice vinyl coating, so that's going to protect the decal from chipping and fading.
It's going to protect it from water, chemicals, and UV rays. Now, that's going to sit on a polished stainless steel base. It's going to give a nice mirror-like shine. The base and the sleeve are going to be made from stainless steel, so that's going to be highly resistant towards rust and corrosion. We're going to have a nice, one-piece riveted construction, so now assembly required. It's ready to be installed in your hitch right out of the box.
The only thing that you're going to need to provide separately is going to be a hitch pin and clip, or a hitch pin and lock. You can see right here that it has three pin holes. This will receive a standard, five-eighth-inch pin and clip or pin and lock. Again, the unit's designed for two-inch by two-inch trailer hitch receivers. A few measurements we want to go over with your real quick, starting with the shank length. That's going to give us a measurement of three and a half inches.
Measuring to the center of that first pin hole from the back of that face plate, we're looking at one and eleven-sixteenths of an inch; to the center of the middle pin hole, we're looking at two and three-sixteenths of an inch. Into the center of the rear pin hole we're looking at two and eleven-sixteenths of an inch. The face plate is going to give us a diameter of four inches. The product is made in the USA, and it's going to be covered with a lifetime warranty. That's going to do it for today's look at part number AUT-POW-C.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.