etrailer Anti-Rattle Locking Hitch Pin - 2" Hitches

Video Transcript for Review of etrailer Hitch Anti-Rattle - Anti-Rattle Hitch Lock - e43JR

Hello everybody, this is Jeff at etrailer.com. Today, we're technically at the etrailer anti-rattle locking hitch pin for two inch hitches. Now, this is a trailer hitch receiver lock. It's used in place of a standard pin and clip to help prevent theft of your two inch hitch accessories. This is designed to work with the threaded D-shaped hitch pin receivers. This is an anti-rattle pin.

This will reduce the play and vibration in your hitch connection. And it does use a pick-proof screw and lock mechanism to provide security. The rubber end on this end and then the textured lock core gives you nice easy grip on it. And then you can notice, it has the attached plastic cap that'll cover the key slot. That'll prevent internal corrosion.

Does include two reversible automotive style keys. When we say reversible, you can see they're cut on both sides. So when you insert it, it can go in either that way or if you put it in the other way, either way, it doesn't matter which way, any way you put it in, it'll work. And then to open it, you just unscrew it like you're unscrewing a bolt or a nut. And once you get it far enough, it'll come right off and you can insert it into your hitch pin hole.

Now, these locks can be keyed alike to match other locks. The way to do that is you just select keyed alike from a dropdown menu that's at the top of the product page and then enter the number of locks into the quantity box. Then when you go to put it back on, just line it up and then just start twisting the key like you're tightening it down and keep twisting it clockwise and you'll notice it gets tight, back the key off a little bit, remove it, put your cap on, and you're all locked and ready to go. Application again, this will fit hitch accessories with the D-shaped threaded hitch pins that fit two inch by two inch trailer hitch receivers. Pin diameter on this is 5/8 of an inch.

The inside pin length or span, which is that measurement, is 2-5/8 inches. The overall length with the lock installed is gonna be roughly about 6-5/8 inches. If we take the lock off, go ahead and unscrew it, without the lock on it, you can see probably right about 5-1/2 inches. The bolt thread size on this is 12 millimeters by 1.5. But again, just to put it back on, line it up, start twisting the key, and once you twist it a couple times, it locks in, back the key off, remove the key, put the cap on, and you're all ready to go. Just like that. But that should do it for the review on this etrailer anti-rattle locking hitch pit for two inch hitches.