These covers protect 4 tires on your parked RV. Guard against water, dirt, and UV rays. Overlapping seams and double-needle stitching ensure durability. Covers easily slip over tires and secure with Velcro straps. Fits 24" - 26" tires.
Features:
Specs:
These wheel covers are designed to fit 24" - 26" diameter tires. For best results when covering larger tires, lay the cover in the sun for a few minutes before installation. This allows the material to expand so that it will more easily fit over the tire.
Fits the following tire sizes:
Accelerated rubber breakdown, which is commonly seen on tires as cracking and dry rot, can damage your RV tires if they are left unprotected during the offseason or simply when parked for extended periods of time. This sidewall cracking and dry rot can lead to blowouts once you get back on the road. Adco's Tyre Gards are designed to protect your tires from cracking and other hazards including UV rays, ice, snow, dirt, and the unwanted attention of animals. Designer Series tire covers are made of a heavy-duty, flannel-backed vinyl with overlapping seams and double-needle stitching to ensure durability.
Easy, Secure Installation
The wheel covers install easily with a Velcro rear fastening system with brass grommets. Simply thread the vinyl strap through one of the reinforced grommets on the backside of the cover. Then slide the cover over your tire, thread the strap through the other grommet, and attach the Velcro ends. This prevents the cover from blowing off in the wind.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
What's up everybody It's AJ with etrailer.com. Today we're gonna checking out the Adco Tyre Gard. Now these are gonna work on RVs and motor homes. And the one we're gonna be working with today is gonna be the one that fits from 30 to 32 inch diameter wheels. You see, we have one of 'em installed already. It's gonna be a nice way to protect that tire if you've already winterized your rig and it's sitting out there.
You wanna cover up those tires so the UV Ray don't bother them. It doesn't dry rot and the elements don't get to 'em. It's gonna be a good way to cover that up. Let's check it out. Now, right away let's just go into how it installs, because you wanna get this on there as quickly as you can.
You don't want it to be a pain. So, looking at it, make sure it's got like a bungee top here. So it's stretchable. So it's not just one of those covers that you're gonna have to stretch out yourself. It can be kind of a pain to put on there.
So I like that, that you have a little bit of mobility to like stretch it out and put it over there. The inside's got felt so it's gonna protect your tire on there too. So it's not just this part that's gonna be rubbing against the tire and wheel. So you don't have to worry about scratches with that. It's gonna be nice and insulated and help out that tire.
So, all we're gonna have to do is stretch it out like this, come down to the tire and just kinda put it over the top. Now it's gonna take me a little bit on this one just because we have low clearance with the wheel well. It's kind of getting in the way, but I just slowly work it back there. The cover just goes right on. So again, it's not really the cover that's gonna be difficult on this one. It's just the low clearance I have, but the Bungee or the stretchability on the back makes it far easier to get this started. So just kinda working it on both sides of the tire and then pull it down over the tire. Okay. Look around the back here. There we go. The other nice thing I wanna point out while I'm here is I still got the tire chocked so I didn't have to remove this to put the tire on or the cover on the tire. So I like that. That's not gonna be a dangerous thing to unchock it and have to completely put the tire on here, cuz you wanna be able to take these off pretty easily too just in case you need to move it around. So I got that sorted. I'm gonna come back on this side, get this adjusted. There we go. Now with it pulled down you get this strap, it has a hook and loop on it. So this is gonna go around the backside tire and hook up to this side if you can see over here. So I'm just gonna put this around there. Keep it to the bottom of the tire, try and push it over there. Then I'll come back here, bring it across. There have been some comments on the sites that the strap could be a little bit longer. We didn't have any problem on our front tire. Looks like it's still gonna make contact on the back tire, albeit not fully covering the hook and loop. So it looks like 25% of it is gonna make contact and hold it right there. Now I can come back here and just kinda try and pull it down a little bit. Maybe get a little more out of it for that strap. There is also eyelets at the bottom and you could run a bungee that way too. If the strap's just not making enough contact and pulling tight enough for you you can run a bungee to really pull that in together. Taking a closer look at the Tyre Gards. So these are gonna be made out of a water resistant vinyl. So if it rains or something it's just gonna run right off of there. And that's same with the snow. It's not gonna stick to it as well. It's also two tone as you can see, tan. So it's got the light tan here and the darker tan at the bottom. We've got the double stitching all around. It even has a seal over it. So all these lines you can see are gonna have that double stitching underneath there. I like that it's not pulled super tight, you don't have to worry like it's gonna rip, you know, when you. Sometimes the form fitting ones are nice, because they go right over there. But then when you go to remove 'em or put 'em on, sometimes you might pull a little too hard and rip it, then you've ruined your cover. Cuz the whole point is cover up your tires so that the UV rays don't break it down. It doesn't dry dry rot and it doesn't have dirt build up either. You don't want any of those issues, because tires on, tires in general are kind of expensive and you don't have to buy those or even mess with putting a new one on. Why not protect it when it's the not new So if you're leaving it, your rig, out all winter and you don't want those tires breaking down. You don't have to deal with that when you go to open it up and bring it out for the first time the next spring. One thing to look at is your tire size. So you're gonna get the tape measure out if you're not sure what size you have. I'm just gonna go side to side and get the diameter of the tire to know which cover I need to the order. Cuz they do have a bunch of different covers for a bunch of different sizes. Then it goes from 18 to 45. So looks like our tire here, if I go end to end, from there to there, is about 30 inches. So I know I need to get the one that's between 30 and 32 inches. And that's what I got. So that's why it fits so well. That's a little more baggy on this one. I imagine it'll get a little bit tighter the closer you get to 32. Overall I ended up really liking these Tyre Gards. The important things for me, they we're easy to put on there and they felt like they we're durable. So with the double stitching and just messing with the material didn't feel like they we're gonna be so tight that they we're just gonna rip if I had pulled a little too hard on either direction. That can always be a pain. So those we're addressed. I like the way that they fit on there. And I like that I can leave the wheel chock. It covers that up too. So it's not an issue to take that on or put that off, Because you wanna be able to easily take it off there when it's time to bust this out and clean it up and get ready to go back out for spring. But right now, as you can tell by the way I'm dressed, it's not spring. So we're just gonna leave this like this for the winter. And I know that the tires should be just fine when it's time to take it back out. Well, I think that does it. Thanks for hanging out and I hope this helped..
Average Customer Rating: 4.4 out of 5 stars (8 Customer Reviews)
These covers protect 4 tires on your parked RV. Guard against water, dirt, and UV rays. Overlapping seams and double-needle stitching ensure durability. Covers easily slip over tires and secure with Velcro straps. Fits 24" - 26" tires.Nice units....fitting a 26 inch tire ia a challenge and the velcro tie straps are too short/ not useable (maybe better fit on a smaller 24 inch tire?...otherwise, they will work ..
The quick delivery was great!! The covers look well made.
Just as expected. I’m happy!
Fast friendly service
Nice, perfect fit. Thank you
Excellent workmanship the color is true to advertising and is very rich looking.
Review from a similar Designer Series Wheel Covers in Covers
We are not happy. These cover fo not begin to fit our 19.5" wheels. We are beyond disappointed. We will be returning them asap.
Review from a similar Designer Series Wheel Covers in Covers
I was very impressed with the detailed e-mails I received keeping me up-to-date with my order. The order was exactly what I wanted. Nice quality product. Will definitely order from etrailer again. Thanks
Do you have a question about this Cover?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.