CE Smith Spool Roller Assembly for Boat Trailers - Galvanized Steel and Yellow TPR - 5"

Video Transcript for CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10451G Review

Today, were going to review part number CE10451G. This is the C.E. Smith, spool roller assembly for boat trailers. This roller assembly will support your boats keel for easy loading and safe transport on your trailer. Its five inch yellow thermal plastic rubber spool roller wont mark your boat, and the galvanized steel panel bracket has slotted mounting holes for adjustability. This assembly is typically installed upright on the front cross member of a boat trailer.

A spool roller panel bracket assembly helps to keep the boat moving while it is being loaded and to stabilize the keel. This spool roller will support your boats keel as it sits on the trailer. And it prevents the bow of the boat from making contact with your winch. Thisll help ease loading and unloading of the boat. And it helps to absorb the road shock while the boat is being trailered.

The panel bracket, right here, lets you bolt your roller assembly on to the front of your boat trailer. It has the slotted mounting holes that allow you to adjust the position during installation. And it does require half inch or seven sixteenths fasteners to install it, which are not included. The sturdy galvanized steel bracket resists corrosion. These galvanized steel parts are hot dipped in zinc, after being stamped.

This creates a coating that is typically three millimeters to five millimeters thick. And this thick all around coating will allow the galvanized steel parts to provide years of use without rusting or corroding. This does have gussets on it. Theres three on each side. So these six gussets will provide extra strength by stiffening the bends.

The roller is a yellow TPR roller, which is a Thermal Plasticized Rubber, which delivers a superior, long lasting performance. The TPR material is non-marking and its stronger than rubber and softer than polyurethane. This part is made in the U.S.A. And to give you a few dimensions on this. The roller length is going to be five inches. This does ride on a shaft with a size of five-eighths of an inch. The dimensions of the mounting slots is going to be half inch wide and they are five inches long. The spacing of the mounting slots from centre to centre is going to be three inches. And the overall size of this bracket is five and a half inches by six and a quarter inches. And again this part is made in the U.S.A. And that should do it for a review on part number CE10451G. End of AudioDuration: 3 minutes, 8 seconds .