Most Popular 1001 - 2000 lbs for Ram 1500

I have a Jeep Wrangler and the back door would not open because the neck of the jack that came with the trailer was too tall. This neck - when lowered all the way, does not impeed the door from opening. I talk with a rep before ordering. She was very helpful and got me the correct product.

This is an excellent replacement for the jack on my Legend 16' V-nose with aluminum frame, it was easy to install, mounting flange matched perfectly. This style trailer sits very low and has always been a headache going in and out of gas stations, ect. The original style Jack foot hits "sometimes very hard," even when the jack is cranked all the way up. Now I rotate the top pin, remove the bottom foot pin and remove the complete Jack and store it in the back of the truck, takes 30 seconds.

I needed a swing jack for my 25' boat trailer, to move it around without hitching to my truck. As you can see, by the pictures, I bolted on a 10" lawn / garden swivel caster to the foot of your jack. This way I can drop the jack down and raise the original jack up (which has a too small wheel that sinks into my soft yard). In this way I use my lawn tractor to move the boat around my yard. Hitched to my truck and the rig is to long to maneuver.

This jack is perfect. It fits my trailer well, seems well built, and was easy to install. Some of the other jacks I looked at locally seemed like they were mounted loosely and would rattle around. This one is tight against the trailer and doesn't rattle while driving.

Worked perfectly for supporting the rear of the trailer for loading my tractor Mounted one on each side on rear of trailer

Good inexpensive jack. I ordered two. My use for them is somewhat "off label". My 19" 9000# capacity flatbed trailer has a label on the dovetail indicating that the rear of the trailer should be supported for any loads over #3000. Personally I think supporting the rear for a trailer is always a good idea when loading and unloading. It puts less strain on the rear of the trailer and it prevents the trailer from lifting the rear of the tow vehicle during loading which can be extremely dangerous. I had a friend weld the tube mounts on each side of the rear of the trailer. See pictures below. Now I don't need cribbing or chunks of wood to shove under the rear of the trailer. These will also adapt well to uneven ground. They can be stowed horizontally, like in the picture or removed when not needed.

Mounted on the bottom of the new trailer jack i bought from etrailer. Everything works as advertised. Fair price and great customer service

seems to be good frame jack

The jack was in stock, the shipping process started immediately, and it was delivered when promised! Thank you.

Replaced original on the trailer. Works perfectly and easy install.

The jack on my cattle trailer wore out. I ordered a replacement from etrailer and within a couple of days the new jack was delivered. My son, a welder, cut the old jack off and installed the new jack. The new jack is so superior to the old one. The ability to turn the jack parallel and out of the way is great. I am sending before and after photos. Thanks for the great service and product!

The action is smooth and the construction sturdy. A+

I received Reese jacks instead of the PRO SERIES JACK as pictured.

Very heavy. Replaced an OEM with a wheel. I much prefer the foot to the wheel. Install was ok. I simply used the existing mount and the original snap ring. The snap ring shipped with the mount was a little thicker and I couldnt get it to work. I saved the weld on mount for another trailer I'm building.

The perfect jack for low clearance trailers! I had trouble finding a jack for my bumper pull horse trailer that wouldn't drag the ground pulling into gas stations, parking lots, etc. I looked at all the farm and home stores in my area with no luck. I thought maybe it didn't exist...then I found etrailer. The short extension below the mount on this jack was exactly what I needed! When fully retracted, it extends no lower than the hitch. I gained five inches from the previous jack. Great peace of mind when traveling and much less worry about dragging when I need all the clearance I can get! Thanks etrailer...and the video was excellent in helping me make sure I was getting what I wanted!

Nice addition to my trailer. I spent a lot of time looking for a jack with a short "hang down " distance from the frame to the ground. This one is perfect. The trailer rides low and will bottom out without a short "hang down".

After a year being stored outside on the trailer, it is working just fine

The trailer part was delivered on time and the unit was the right item, the first time.

Makes life so much easier than lifting the front of the trailer all the time.

Perfect. Needed a jack for my off road utility trailer which is only 2” square. Just what the doctor ordered. Super fast shipping. Awesome customer service. Thanks.

Didn't know back in 2001 that the Fulton jack on my brand new Javelin boat trailer was as tough as it has been. No garage, no concrete. Just a metal carport sitting on dirt. Took 23 years of abuse (no maintenance very little greasing) to finally give out. I know it's unusual for someone to keep a boat that long but I love it and I don't plan on getting rid of it. Hopefully I get another 23 years out of this Fulton

Hey have to give to etrailer.com fast shipping and jack was exact fit

It works perfect for our trailer right out of the box and is continuing to work for us. Thanks so much.

Overkill for my little 5x8 utility trailer, but it looks and works great!