Most Popular Electric Jack for 2017 Forest River R-Pod Travel Trailer

My Jack arrived DOA. After installing it on my trailer, the Jack didn’t work. The manual crank handle came in handy because I didn’t have time to troubleshoot and repair it at the time. It was just a wire that was no longer connected to the switch but I have to tell you it was extremely disappointing to receive a brand new item that didn’t work. If it had worked out of the box, I’d give it a five star review. You should consider soldering and heat shrinking the wires to the switches or making the wires longer so they aren’t banjo string tight and putting the lug at a strange angle.

This particular jack fit my 2001 Horse trailer perfectly. I had it installed in about 2 hours due to clearances on this particular type of Tonge design. Otherwise with a couple box end wrenches and a hydraulic bottle jack this jack could be installed in 30 minutes. It appears to be a very good product for the money. Also, it has plenty of lift capacity. 8000 pounds which is perfect for my trailer.

One small part was missing from my Ground Control TT. Carol Korren expedited delivery of the missing part and the UPS truck pulled up at the moment I needed the part. Fantastic customer service!

This works great and has been the very best upgrade on any RV/Trailer I have every owned. I will never own another trailer that does not have this.

I should have got one years ago. I only use it when it's connected to the truck with the engine running. This I believe gives me full power. It has enough power to raise the trailer when connected to the truck to get the anti sway bars attached. Sure beats all that hand cranking.

The alternate power setup makes its slow rate of rise necessary which would be good if my lithium batteries went low. To avoid battery problems be sure to add an inline battery disconnect from the trailer power when using tow vehicle power. I simple added an inline fuse that could be removed should I need to use the tow vehicle power.

It installed very easy. For a 2500lbs jack, it seems a little light weight. It does lift the trailer but seems kinda wobbly because the post size is so small. Other than that it works as advertised. Thank you for getting it to me so fast.

I just installed my new JET-2500 trailer tongue jack in less than 15 minutes. The light and extend/retract work great. I was not sure if an adjustable drop foot is available for more length but do not think it is needed. This is second purchase, first being Equalizer hitch system which is also even better with electric jack. Etrailer exceeds customer expectations by follow up email and definite concern to keep their customers satisfied. Great Company! Thank-You Ron Williams

The powerhead is very large and extends forward, which has caused it to impact upon two different vehicles when backing the trailer. The power function is now useless, and I am using the manual crank to raise and lower the jack.

Sturdy jack, easy to install. We installed it facing to the driver's side so we can still put our tailgate down. Very powerful jack, only drawback is it is very slow.

Overall the product does exactly what it's intended for and works well. I however assumed that this would be a simple R&R for my camper and did very little installation research other that the video provided on etrailer' s website Sadly it did not fit. Not at all. I didn't take into account that have a double framed hitch toyhauler. The baseplate on the factory leg was a TRIANGLE.....this unit was ROUND. Also the primary shaft was thicker than stock and would not drop down into place I know modifying is frowned upon, but I found that ALL powered hitch legs I found have round mounting plates and it's not mentioned the leg tube is thicker than OEM? Since NOT having a power lift wasn't an option for this camper application...too heavy in the front when ATVS loaded to lift for setting the equalizer hitch tension bars, I proceeded to modify by cutting the rear rounded mounting base ... square. Took off about 1/2 inch. Then I took my metal Dremel sanding bit and increased the hitch leg hole diameter slightly. Took about 1 hr. Dropped it in. Wired it. Tested it. All good. If you can't post this I understand, but take note that some of your website descriptions may need to be enhanced. Thanks!

I ordered the Reese Bulldog 4000lb power tongue jack on 6/2 and received it on 6/6, my second order from etrailer and it came just as fast as the hitch that I ordered from them previously. The jack was characteristically well packaged so everything was received in perfect condition. The installation took a half hour, including hitching the trailer up to my truck and unhitching after the swap out. I did read the instructions quickly before starting and I would recommend that anyone doing the installation do so as well, just to avoid any hick-ups. Overall it was a very easy installation. Because of limited space I did have to mount the jack sideways, so I appreciate that Reese gave me that option. The one item that I did not finish was a permanent power hook-up. The power wire provided was too short so I will be putting a connector inline so that I can route the wire to the battery terminal.

Hello, Please see pics below of broken weld on jack. The jack was just installed and in use for about 7 days and noted the broken weld. Jack functions as described, however, we question the durability of the jack.

Definitely has the power I need however I can't open my tailgate when my camper is hooked up. 5 stars for power.

These are great jacks. I have 3 of them. The only reason I replace one was because I bent it. Let's not go there.

This jack was the perfect solution for my application. I have a new enclosed trailer that came with a manual crank and only a tiny battery to run the lights. I did not want the expense of having to buy and cable up a larger battery to just support the tongue jack. Took me 5 minutes to install this new jack using the three bolts that were already on my OEM jack. Now I just back up my truck, plug in the 7-way, and I'm able to move the tongue up and down as needed. Great!

I purchased this jack to replace my tired 10 year old camper jack . I ordered it at 10:00 AM Monday and as promised by Ian it was at my doorstep on Friday just in time for my weekend getaway . Installation was a breeze . I gave the product a 4 out of 5 for a few reasons . First , I was not able to see the manufacturer of the jack before receiving it . Which made name brand comparison pricing difficult . However I feel pricing was on target . Second , I feel that the jack should come with a battery terminal end connector and new mounting bolts with the hardware that was included . This didn’t pose any difficulty to me as I had hardware at hand but for some it will mean a trip or two to the hardware store . Third , once installed , at least with my truck and trailer , unless the truck and trailer are perfectly aligned and level the jack motor gets in the way of opening the tail gate . On first use I noticed it was much slower than my original but the strength made up for it . This jack had no difficulty or hesitation lifting my truck and trailer for load distribution and anti sway bar installation . I would recommend etrailer and this product . Time will be the final test of its durability .

Ok.... the customer service from ETRAILER totally saved the review! These guys are incredibly awesome. I ordered 2 of the jacks. The first came with a broken housing cover , the light had beed disloged, and the up down switch was wired backwards. (Up would put the jack down and down would put the jack up) Solution? Glad you asked! I contacted ram about the cover.... waiting! The light was easy to correct, just had to slide it back into the slit that holds it. Switch, well.... if-your2 not comfortable with wiring, I recommend not even attempt to rewire. I just popped it out of the cover, twisted 1/2 turn, popped it back in. Total time to correct.... 8-10 minutes. Total time to install, 15 minutes. Total job less than 30 minutes. Would I recommend this jack... YES. Despite a shipping issue to crack the housing ... its easy to install, price right, powerful. I dont have to hand crank. Simple correction to the switch. And they could use some r&d improvment on the light... but excellent jack! It does what i meeded it to at an affordable price!

This was a great replacement for our 4 year old Keystone Springdale trailer jack that bit the dust. Installation was easy and is much faster and quieter than our RAM jack that came with the trailer. I did sand down the paint on the contact points to make sure of a good ground then painted over what was exposed. I liked it so much I'll be looking at getting one for my large utility trailer.

The machine is great. The auto up and down make life easy I had trouble with my first one I bought. One of the wires on the controller was loose. It was promptly replaced and the other one has given me no trouble at all.

This Bulldog replaced an Atwood jack on our Lance 1575. The Bulldog is quiet, but there is a fair amount of play between the inner and outer tubes. It feels unstable even when fully retracted. This wasn't the case with my old Atwood jack. If I had known this, I would have gone with another brand. I bought the Bulldog based on the reviews and the warranty, so I was surprised that there is so much wobble in it.

Installation was quick and easy per the instructions and eTrailer video. One of the few times I've had something "bolt right in/on" LOL. It has worked flawlessly in the time that I've been using it. The only drawback, and it is a small issue, is that it is easy in the heat of battle to bump the light switch ON and not see it in the daylight. One just needs to be careful or use a bit of tape to secure light switch OFF until needed. Another great product from etailer.

Ordered a power stabilizer jack for my 2012 Jayco fifth wheel in 2023 , easy to install the item myself , stabilizer working great , will buy future items at this site , thanks

The stabilizer works well. I would buy it again

This is what I needed. I Wanted a little more lbs. of lift so I could lift my truck for weight bars and such. I have a 2014 Rockwood A Fram and needed the mounting holes to line up. After some research, I found Stromberg jet-3755 worked perfectly. I have used it for a year now and no problems. Easy to set up and use. Thank you etrailer

Item arrived a day early. Installation was easy. Jack works smoothly. 3500# rating is 500# better than the factory installed jack.

Got my product when promises. exactly what I ordered ( and on sale too) Alex was great. I WILL BUY HERE AGAIN

Finally got around to installing my PT II Stabilizers 30" front and rear of our 26' Surveyor. Pre - assembled them to make sure they went together ok. Luckily I had two sources for power front & rear which made wiring easy, I used a Buss block to make all positive connections, grounds straight to frame, soldered all connections and heat srinked to seal. Using the 3/8" self tappers was fun.Well got it all together and all works well makes trailer very stable, don't have to worry about scissor jacks collapsing anymore.

The product works as designed. Easy to install and I have used it approximately 20 times in the last year. The storage for the 7 pin connector and safety chains are a great option. Keeps things nice and tidy when unhooked. I highly recommend this Jack.

Perfect fit and operates very quietly and with abundant power for my 27 foot Lance travel trailer. The Jack-It Lippert bike rack mount fits perfectly over it, and the manual emergency jack crank fits within the tube of the Jack-it if the need arises. Also, the handy ring for stowing the trailer chains and receptacle for stowing the 7-way connector is a nice feature. Very happy with my purchase, and etrailer is fantastic, as usual!

excellent jack, but a tough fit on an Escape 21 ft fiberglass trailer, as the propane bottles are /right/ behind the jack

The bull dog electric tongue jack is awesome. I got it in white to match my trailer. I unbolted the old jack and bolted on the new one in about 5 minutes. (I had my coreless impact gun.) Total install time was about an hour mainly because I wired the jack to my battery inside the trailer that runs the electronic winch and I had to run a separate ground from the battery to one of the mounting bolts for the jack with a cut off switch. So far it works great but time will tell. I'll be using it a lot more next year.

We replaced our 3500 lb jack with this one because we wanted something faster and stronger and this jack is all of that. However, the number 1 reason we bought this jack is that it is easy to mount the head 90 degrees so that you can easily drop your tailgate down while hitched to our camper. It was easy to mount and it works like a charm.

We use this on a portable egg mobile in Maui, HI with very rough agricultural terrain. It gets moved 2 times a week and it is working like a charm! Saves lots of time in the field. Mahalo Nui Loa - Thanks very much, for a great product. Attached is a construction photo of the egg mobile.

I received the stabilizer and it sat in the shop for weeks before I was able to inspect it due to outage work. After removing the old stabilizer I opened the package to find it was incorrect. There was no motor,switches, wiring or fuses basically the manual version. After contacting Etrailer and explaining the problem they sent 2 motors, no mounting bolts or all the other electric. Was told it was past the 30 days for shipping proper material,WTF. Extremely disappointed, no more business from me.

Installed on a 2018 E350 Ford Minnie Winnie. The package arrived really beat up but only a single cover was damaged. It was replaced quickly. Nothing was missing. I had to shim it down from the frame about 1.5 inches using a bar of 1.5"x3"x 24" inch aluminum stock on each side. Then it would clear the fuel tank and the gray water. Switches are installed in our garage under the bed. Wiring came from power panel which is fairly close to the switches so it all went fairly well. Wire nuts are not recommended so I had to hunt around to find connectors that would work. I have not used it for camping so do not how well it will work to stabilize the vehicle. We do a lot of boon docking so will have to have some good blocking to level and stabilize. It feels a little better sitting on the street. I do wish there was a lockout for them being raised before moving the vehicle outside of PARK?

I really enjoyed working with Lauren she really knows the product line and the Ultra fab landing gear work far better than I expected. I have a 2019 Genis Supreme 33CKXL I highly recommend this product.

I recommend this landing gear set to everyone!!!!! After 2 replacements of tandem landing gear sets performed by dealership under warranty and still struggling lifting my 5th wheel, I decided to purchase this upgrade on my own dime. Best money I’ve spent in years. These lift my 15,000-16,000 5th wheel with no issues. Consistent and quiet. I don’t stress out anytime I’m hitching or unhitching anymore. 100% recommend buying. I’ve already talked 2 of my friends to do this upgrade and they love it.

The cover over the light on the jack was not attached and there was a piece broken on the case. I thought of sending it back but decided quicker and easier to just repair it myself. See photo

After a year still works great……easy to install, and didn’t need the light because I had already installed a rear utility light to my truck to hook up trailers but for those who don’t have a back light it is much easier than a flashlight. Great product!