bing tracking image

Best 2013 Toyota RAV4 Trailer Hitch Ball Mounts

change vehicle


Trailer Hitch Ball Mount Videos

Install: Draw-Tite Ball Mount for 2" Hitches on a 2013 Toyota RAV4

Play video Install: Draw-Tite Ball Mount for 2" Hitches on a 2013 Toyota RAV4

Today on our 2013 Toyota Rav4, we will be test fitting the Draw Tite Ball Mount with a 3/4 inch rise or 2 inch drop with a capacity of 7500 lbs., Part #2923. We will begin out test fit by getting our hitch height, this is the measurement from ground to the inside top edge of our receiver tube. So our Rav4's hitch height is about 13 inches. We will now take our ball mount install it in the drop position being sure to line up our pin holes and securing it with a pin and clip. We will not take a measurement from the ground to the top of our ball platform and this will be around 11 inches. Make sure to measure your trailer height when your trailer is level. Measure from the ground to the bottom of the coupler. If your measurement matches ours, this would be a correct fit for you. We will now turn our ball mount to the rise position.



How to Install the Curt Tri-Ball Mount on a 2013 Toyota RAV4

Play video How to Install the Curt Tri-Ball Mount on a 2013 Toyota RAV4

Today on our 2013 Toyota Rav4 we will be test fitting the Curt Tri-Ball Mount Hollow 2" Shank, Part #C45001. To begin our test fit, we'll measure our hitch height from the ground to the inside of the top receiver tube of our hitch. Our measurement here is about 13 inches. We will slide the shank of the ball mount into the receiver tube of our hitch, line up our pin holes, slide through our pin and secure it with a clip. When installed, the height of our ball mount will be equal to our hitch height. Make sure to measure your trailer height when your trailer is level. Measure from the ground to the bottom of the coupler. If your measurement matches ours, this would be a correct fit for you. By removing our pin and clip, we can rotate to the left exposing our inch and 7/8 inch ball.



Beginner’s Guide to Installing the Convert-A-Ball Ball Mount for 2" Hitches on a 2013 Toyota RAV4

Play video Beginner’s Guide to Installing the Convert-A-Ball Ball Mount for 2" Hitches on a 2013 Toyota RAV4

Today on our 2013 Toyota RAV4, we will be test fitting the Convert-a-Ball cushion ball mount for two inch hitches with three-quarter inch rise, two inch drop and a 10,000 pound towing capacity, part number amsc2. We will begin our test fit by getting our hitch height. This measurement is from the ground to the inside top edge of our receiver tube. It's about 13 inches. We'll install the ball mount In the drop position, sliding the shank of the ball mount into the receiver tube of the hitch, line up our pin holes and secure it with a pin and clip. To get our measurement, we'll measure from the ground to the top of the ball platform. It's about 11 inches. Make sure to measure your trailer height when your trailer is level.