Most Popular - 0 Inch for 1981 Ford F-100, F-150, F-250, F-350

My newer Chevy K3500 has a 2 1/2 inch square receiver so I was able too get rid of my 2" ball mount that was almost too heavy to lift and replace it with a new Reese tri- ball mount with a 14,000 lb Gross towing capacity and weighs less than 12 pounds. Thanks to Cathy H. and Chris W. at etrailer.com for finding the right equipment for my needs.

Despite some of the conflicting reports on here about the Reese Tri-ball Titan Hitch fitting 2011 and up Super Dutys I took a gamble and it payed off. It fits my 2012 Super Duty with no issue. I didn't have to grind the corners or take the sticker off or remove any paint. Thanks for the great customer service and answering my questions.

This is really nice. Beveled edges so it slips into receiver hitch so sweet. Beautiful welds heavy weight mount for my weigh safe ball. I bought a 10,000 lbs hitch and I wanted a draw bar with the same type rating. Now the only thing limiting my trailer capacity is my truck's ability to tow, not the hitch, bar or ball.

I purchased a Ranch Hand rear bumper for my 2500HD but wanted to retain the use of a receiver hitch. The ball mount would need to extend 8" from the pin hole to even reach the edge of the bumper. This BM29 ball mount works out perfect. The welds look great and the finish is just fine. The only complaint I have is they gained a little length by moving the pin hole a little closer to the end shortening the insertion amount slightly. Not a big deal, it is just noticable next to the other mounts I have at the house.