Best 1981 Chevrolet El Camino Trailer Hitch Ball Mounts

The welding splatter found its way to the hitch pin hole and it took me some time with a Dremel to clean it out so the hitch pin would slide in.

Each edge of the hitch receiver shipping carton was pierced by mounting brackets, but no damage fortunately. Consider adding another layer of cardboard padding?

It's a awesome hitch and it fits perfectly good on my 1986 chevy elcomino to pull a trailer some time

etrailer has what you need

As described

works well brings the trailer tongue up to level. I have it on an EV so the raddle is annoying, because I just keep on forgetting to buy a anti rattler.

Wonderful product. I had the hitch installed in 10 minutes. The wiring was a little more tricky because it required running a power wire all the way to the battery. I towed my trailer from Florida to Tennessee and back. Etrailer is still wonderful to deal with as they always have been in the past. My hitch came in a couple of days. I wouldn't think of ordering from any one else.

I installed this on my 2015 Honda Accord for the purpose of pulling my small aluminum fishing boat and trailer. Works great!

The product is good but a bit tideous and after installing it my bracket fell and it was a pain to get replace it support made me buy the replacement pieces and the bracket didnt come with just the bolts, and at the end they told i have i had to buy the whole unit because based on their system my truck didnt have issues with installement and the manufacturer didnt supply that bracket cause it special order so in general i dont recommend in my choice better to get it welded.

Working in the sand and grass of my driveway my wife and I installed our new etrailer receiver hitch. Great fit and finish! Went right on as described in the online guide. Hitch required a spacer washer on top back bolt attachment point. Taped it on so it would not move while lifting in place and it stayed right there! Used a car jack to raise up and hold the hitch into the underside of the trunk tighten the bolts and reattached the tail pipe done. Now we can pull our Sunfish Sailboat any where the car will go.

I am an infrequent trailer user, but getting my daughter home from college was necessary in March. This drawbar fits my hitch and utility trailer well, did exactly what it is supposed to do, and was the last thing to be concerned about right then. I have a '11 Mini Countryman S with a Class II receiver from Mini Fini, (which cost twice as much as a Curt) where the hole is flush with the fake grille near the bottom of the bumper cover, so I needed the long bar to reach out past the bumper. The Curt receiver for that car hangs visible underneath the bumper (ugly), which also increases the lever arm on the receiver beam and would have needed an even taller rise. (Curt take note!) All just part of the kit to create an occasional 1 ton pickup out of my Mini, leaving the "bed" at home most of the time.

This drawbar did exactly what I was hoping for. It leveled out my trailer and took the weight off the tongue. Perfect!

Great product. Fit and finish is excellent. I've mounted the Curt 1 1/4" hitch to my 2007 Mazdaspeed3. Taking the rear bumper off, which only took 30 minutes (maybe a few minutes more than that) made it very easy to attach the Curt hitch to the car. I wanted to compliment the Mazdaspeed3's overall appearance, so, I decided to go with the Curt euro ball mount 11 3/4" . Very pleased with the outcome.

This worked out to be the perfect ball and mount for my purpose- occasionally having to use my car to tow my utility trailer. I got this and the DrawTite receiver hitch for my '99 Monte Carlo and everything went together in less time than the estimated time that had been shown. Very happy with both purchases!