Put the power of your system in the palm of your hand. Adjust any brand of air springs (sold separately) from inside or outside of your cab and run diagnostics with the hand-held controller or your smart phone. Includes EZ Mount for no-drill install.
Features:
Specs:
Oh, the power of your index finger. Air Lift's premium, wireless, onboard compressor system with Bluetooth allows you to fill your air springs at the touch of a button. WirelessAIR also automatically maintains pre-set air pressure levels.
With the Air Lift mobile app and your smart phone, you can inflate or deflate your air springs and even run advanced diagnostics without leaving the driver's seat. Additionally, it includes a wireless controller if you would rather use a traditional remote. The system lets you know if there is a leak or if the compressor has malfunctioned. If you want to get a good look at your vehicle while adjusting your air springs, just grab your controller, hop out of your truck and make your adjustments from outside the cab.
As soon as you turn on WirelessAIR, the compressor will activate and fill your air springs to the default level of 5 psi. After that, you can reset your default pressure settings to whatever you like (between 5 and 100 psi) and WirelessAIR will maintain these levels for you, staying within 3 psi of your desired level. Built-in digital air pressure gauges allow you to monitor each spring on your vehicle. You can pre-program two pressure levels for frequently carried loads such as your boat or camper. Also, WirelessAIR senses when your air pressure falls below a safe level and restores pressure to the minimum psi, preventing wear on your air springs.
WirelessAIR has a dual-path controller that lets you adjust two air springs individually. This means that you can get front-to-back and side-to-side leveling. Alternatively, you can configure the system to adjust and monitor two pairs of air springs independently. This way you can put different amounts of air into your front pair and rear pair of springs, allowing you to level your vehicle front to back.
The system comes complete with everything needed for installation, including an air compressor; a manifold; an easy-to-install wiring harness; and a wireless, hand-held digital controller. It also includes the EZ mount for a simple, no drill installation. This mount comes with the compressor and manifold pre-installed on the bracket and clamps to the frame using a U-bolt.
WirelessAIR is compatible with any brand of air springs, and it comes with a 2-year limited warranty.
Alternate Instructions
California residents: click here
Average Customer Rating: 4.8 out of 5 stars (142 Customer Reviews)
Put the power of your system in the palm of your hand. Adjust any brand of air springs (sold separately) from inside or outside of your cab and run diagnostics with the hand-held controller or your smart phone. Includes EZ Mount for no-drill install.easy to install. Push a button, and raise airbag pressure, push another button let out pressure, pretty much wish i had spent the money on this system for my previous truck. I may fabricate a little metal shield to go over the compressor and solenoid/bluetooth package to keep mud and salt off them. I installed compressor behind storage bump out thing to block spray from from tires. I still have to install compressor air intake filter, i am going to install it inside that little storage compartement so compressor always gets fairly fresh cab air.
Joseph - 04/03/2021
After a year the unit has worked as advertised I've not had a issue with it. I did have to take the compressor out of the mounting kit to install it on the 2019 F-350 I couldn't find a place to mount the EZ mount. other that that I've been very happy with it. I did mount the compressor with a vibration dampener works well I don't hear any vibration in the cab of the truck also I made a stand off for the controller so I would not have to move a brake line.
Awesome pump assembly, works excellent as it maintains a consistent pressure automatically to what was set by the operator. The unit was easy to in stall on my 2019 F350 P/U. I pull a Bobcat and a Bobcat mini excavator as well a 36 ft. 5th wheel at times. The pump assembly maintains a consistent pressure for a perfect ride height that was set on my setting. You can readjust your setting manually if needed for more or less lift as needed for your application. I recommend this product as well as the airbags for a great ride and workhorse applications.
After 2 winter seasons my compressor has completely failed. It will not turn on at all
Heather A - 04/26/20222020 GMC 2500. Did LoadLifter 5000 and EZ compressor set up.
The exhaust runs down the passenger side and the fuse box with switched power signal is on the driver side so for multiple reasons I wanted to mount the compressor on the driver side. I couldn’t do inside the rail as I would have preferred given all the DEF and fuel tanks. Above the frame rail running down most of the truck are 2 solid brake lines that would interfere with the U bolt to mount the EZ compressor assembly vertically as I originally intended. I did find a space I could fit it in without interference with those lines but it hung low and was more visible and exposed that I preferred. I did find though 2 existing holes in the frame that the U bolt fit in perfectly for a horizontal mount without interference and much higher and better tucked up under the truck for a super clean mount. The U bolt threads didn’t run deep enough for a single frame wall mount so for $3, I bought steel spacers and after painting them inside and out for corrosion resistance, I mounted very easily for a “customized” no drill $3 option. There is also a large wire harness that runs from that spot all the way to the battery so it was easy to run my wires along side and attach to that all the way up. Very happy with that location as air lines were easy to run and plenty long from there as well and put in 2 service loops just in case.
I ended up running the pink wire to the fuse box and bought some fuse splicer wires Iike in the etrailer video. Hesitated to trim the fuse box on my brand new truck so the lid would close and like to keep mods as unnoticeable as possible so wanted to see how well it performed just based on motion and waking with the remote or app. I’ll wire it later if needed but just left it tucked for now.
I also picked up some Daystar airbag cradles and mounted those to bottom bracket using the existing center hole in the bracket. Just picked up longer SS countersink bolts and hex nuts. No drill but I did have to trim the bolts off for a perfect length. Now the stretch of the airbag doesn’t limit suspension travel down and I don’t have to worry about bag damage when on a service lift down the road. Obviously when under its own weight or loaded the bags fit snugly and are well supported by the cradles. Outside of the time to buy the additional hardware that took zero additional time and is much preferred as now I can take it to the shop without worry. The only draw back is they are 6” cradles and I would have preferred the 7500# air bags for extra duty but they are 7”. I run the same setup on my 2002 Excursion and knew for sure I wanted the cradles so stayed with 5000# bags. I’m not loading a skid steer in the bed so really that should be plenty.
Love the AirLift system and have ran them for years. Glad to have them installed on my new truck and look forward to the next load.
Put pics of bags with suspension full droop, and then under normal weight. Also pics of the mounting location and final mounted compressor set up and look from side of truck.
Would recommend this set up for anyone who uses their truck like a truck and would recommend these minor mods on the install.
Overall very happy with the compressor. Easy to install and being wireless there's no wires or airlines routed into the cab of the truck.
I mounted it inside my toolbox so it would be out of the elements had it been mounted on the frame of the truck. Because of that the air lines that came with it were just long enough to reach the airbags.
Great to be able to adjust both airbags or either in isolation from the cab of my truck or from the rear of my truck camper as I’m leveling at the campsite. This is a pricey option but worth the investment in convenience value!
I like this system. The fact that
You control it with a remote is very cool. I rent out Dumpsters with a 1 ton diesel and these bags have seen some weight.
I was informed it would be longer to get this product but I got even faster than expected. Thank you for your time and have a blessed day.
Texas C - 08/11/2022outstanding product, works great. could use 2 to 4 for meet of hose so you don't waste time finding the right route to take for hose installation because you can run out of hose if you're not precise. but a great investment.
Easy installation and great product Works perfect. Reason not giving 5 stars is we had one install frame bolt bend and one break. Once we drilled two more holes in the frame brackets and frame and added beefed up bolts (#8’s) everything is perfect.
There great haven’t had any problems ! Makes it really easy to adjust the airbags while driving ! Highly recommend them !
It was t one year only 3 months. I ordered it a year ago but received it in February this year. I have it 5 stars as it is a great item otherwise I give it a negative 5.
I've had this air lift system on my 2007 Tundra with a cabover camper in the bed for a year now. Works as designed. Fantastic product!
I am very pleased with the union T and the load lifter kit ,when the compressure and wireless controller arrive ,at that time ,I will have it installed and get some pictures ,till then THANKS .
I was able to help my customer repair his unit.
Everyone that has a truck and uses it as a truck needs air bag with compressor.
This was a simple installation, works g reat
Great product. Took a bit to get it installed in my 2019 Tundra, but was able to do it myself. It's helped with the bounce problem when towing my Trails West 2 horse with LQ goose-neck trailer.
Easy to install and set up. Love the flexibility of adjusting the load and ride stiffness.
The install was easy , the wireless connectivity to the remote is excellent, the ability to adjust while driving and keep it at a set point is great,
Great product. Easy to install. Connection to wireless was flawless and and easy process. I knock 1 star because ordering the bags w/ stainless steel lines is useless since only the nylon hose can connect to the compressor and the T‘s are the same. That’s more a product than etrailer that has great prices, customer service, and fast delivery.
Great service and fast delivery!
Love the product, hated that it took 8 months to get it
Relatively simple to install. However, the U bolt installation method will not work on my 2019 F250, the frame rail is about 1/2 too tall for the U bolt to fit over. I had to use the drill and tap screw installation. Also, I was unable to install on the driver’s side as depicted in the instructions because the parking brake cable is mounted there. I instead mounted on the passenger side frame rail, on the outside, underneath the running board. After installation, no problems functioning with both the remote and iPhone app.
Do you have a question about this Air Suspension Compressor Kit?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.