Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 3/4" Pin Hole

Video Transcript for What to Know About the Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at this replacement female pipe with the three quarter inch pinhole for the Etrailer and Ram Pipe Mount Swivel Jacks. Now this part here will replace the female pipe on your Etrailer and Ram Pipe Mount Swivel Jack. Basically this part here is the female pipe that'll weld onto your trailer frame and allows the male pipe mount that's on your swivel jack to insert into this female pipe and allow it to swivel up or down, swivel it up into the storage position, swivel it down for the use position and as you can see, there's four holes. There are three quarter inch diameter pin holes on here. So basically when you put your jack in there and you put it in the down position for use, you can put the pin in here to hold it into place and then when you're ready to tow, you just pull the pin out, swivel it up, put the pin through the other hole, it'll hold it into the storage position.

Few dimensions I wanna give you on this female pipe mount, the overall diameter on this from one end to the other, right at three inches, inside two and a half inches, total depth on this part, two and a half inches. Now the pinhole diameter, there's four of 'em, we mentioned is three quarters of an inch. I do want to give you a couple measurements of where that pinhole's located on the length. So if we start for the shorter edge, from the edge to the center of the pinhole, seven eights inches, if we measure from the center of the pinhole to the longest edge, it is one in five eights inches. But that's gonna do it for the review on this replacement female pipe with the three quarter inch pinholes for the Etrailer and Ram Pipe Mount Swivel Jacks.

.