Replacement Mounting Hardware for etrailer and Ram Swivel Marine Jacks - 1,200 lbs and 1,500 lbs

Video Transcript for etrailer Trailer Jack MJ-1000B-MBB Review

Speaker 1: Today we're gonna take a look at the replacement mounting hardware for the 1200 pound and 1500 pound E-trailer and RAM swivel marine jacks. This hardware is used to mount the swivel jack to your trailer. It will replace the mounting bars and the bolts for your E-trailer or RAM bolt-on marine swivel jack, and it is designed for use with the part number MJ-1200B, MJ-1206B, MJ-1500B, and the MJ-1500B-BWL series jacks. It does come with the hardware to mount the swivel plate and the jack to the trailer. I just wanted to show you. I pulled one of the jacks.

This is the 1500 pound jack, and you can see it comes with the mounting plate, and when you buy this brand new it will come with the mounting hardware already, but if you want to switch this to a different one or your hardware gets damaged, then you'll need this part number, which is just the mounting hardware, to mount it to the trailer.A few measurements I wanna give you on the mounting bars on the holes. I'm gonna give you the measurement from the furthest hole center to center, right at 5 1/2 inches, and then these holes are at one-inch increments, so it goes anywheres from 5 1/2 at the longest and then to the next hole will be 4 1/2, 3 1/2, 2 1/2. So depending where you put your bolts through, it'll mount the different trailer heights.But that should do it for the review on the replacement mounting hardware for the 1200 pound and 1500 pound E-trailer and RAM swivel marine jacks.