Replacement Quick-Release Levers for Yakima ShowBoat 66 Slide-Out Load Assist Rollers - Qty 2

Video Transcript for Review of Yakima - Watersport Carriers - 8860058

Today we're gonna take a quick look at the replacement quick release levers for Yakima ShowBoat 66 Slide-out Load Assist Rollers. So this is going to be a direct replacement from Yakima, if your handles got broken or damaged or just wore out after long years of use. So you're gonna get the lever handle itself, and then the roll pin, the screw, and the cylinder nut. So this is gonna be the pivot point that sits inside that handle. Our roll pin is gonna go in between the end of the lever there through that cylinder pin or that cylinder nut, and then our screw threads into that. So that allows us to tighten down the mounting brackets on our Load Assist Rollers, tighten that down, turn it, and then cam it over to complete that process.To get those roll pins in place, the easiest way to do it would probably be to use a hammer or mallet, and maybe a punch to drive that in there.

It'll go through the handle just fine, but then to actually get the roll pin through that cylinder, it's just a bit tight, and that's to make sure that it has good pressure there. So, you might have to use a mallet to drive that in place. You could also try some pliers, but that might misshape that cylinder, and make it not have the same amount of tension. So, just something to keep in mind there. A punch is just one of those long skinny tools that you can use to drive things in place.As far as our dimensions, our lever itself is gonna be 2 inches long, and then about 5/8 inch across.

Again, this is a direct replacement from Yakima, so it should work just fine for you.And that's gonna do it for our look at the Quick Release Levers for Yakima ShowBoat 66 Slide-out Load Assist Rollers.