To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Ease installation of your electric trailer brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in port beneath your vehicle's dash.
Features:
To install your electric brake controller, you need to connect the wiring of the controller to your vehicle. Certain auto manufacturers offer pre-wired options, typically known as tow packages, wherein wiring is run for you from the dash to the trailer connector on the back of your vehicle. When this is done, a port is installed at your dash so that you can easily plug in a brake controller.
This adapter plugs into the port on your vehicle's built-in brake control wiring harness. The harness is located underneath the dash, to the left of the steering column, and it is taped to another harness near the emergency brake pedal.
To hook this adapter up to your trailer brake controller, just connect the 4 wires of the harness - ground, power, brake switch, and brake power - to the corresponding wires on the brake controller. If your brake controller came with a plug built into its wiring harness, you will have to cut off the plug and connect to the wires themselves.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're reviewing part number TM75268 from TrailerMate. This is a custom wiring adaptor for trailer brake controllers. It fits the 2009 through 2012 Honda Pilot and the 2006 through 2012 Honda Ridgeline truck. This is an easy way to provide power to your brake controller. You simply plug the gray plug into the factory port that's under your dashboard and then you connect the pigtail wiring to the back of your brake controller using the included bud connectors.The wiring itself is stranded copper so it lasts a long time and it's good quality. When you're finished installing the wiring you can take up any slack using the included cable ties.
The wire when it's stretched out is about twenty four inches long. This custom wiring adaptor is compatible with both time delayed and proportional brake controllers made by TrailerMate, Draw-Tite and Tekonsha and it comes with a limited lifetime warranty.And that's it for part number TM75268 the TrailerMate custom wiring adaptor for trailer brake controllers.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.