SeaSucker Vacuum Mount with Stainless Steel D-Ring - 4-1/2" - White

Video Transcript for A Closer Look at the SeaSucker Vacuum Mount with Stainless Steel D-Ring

Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at the SeaSucker 4 1/2 inch diameter vacuum mount with the stainless steel D-ring. Now this is a 4 1/2 inch diameter vacuum cup, has a stainless steel D-ring connected to it, so to let you hang or secure a variety of objects to non-porous surfaces. It uses a pump action vacuum, which creates 120 pounds of pull strength without having to drill holes or damage the surface that it's attached to. And it will mount to most non-porous vertical or horizontal surfaces. Basically this vacuum cup will install the metal glass or fiberglass in seconds just by simply pumping this plunger.

And I want to demonstrate that. Right here, I have a. It wouldn't attach to the regular table, so I have a piece of metal here, plate here that we're gonna attach it to. So basically what you'll do is put a little pressure on it and then you'll start pumping that plunger. And as you keep pumping that plunger, you'll notice that orange indicator on the plunger will slowly go away.

And when that happens that note means you have enough vacuum in there. So you can see just like that. You let it go, there's no orange indicator. And you can see it's attached pretty good. There again, 120 pounds of pull strength, and you can hang whatever you want to this.

And then to remove it, it's pretty simple. On each end here, they have these little tabs, so all you have to do is pull up on the tab. And when you do that, it'll release the vacuum and you can easily remove it. Simple to operate. Also on the top, if you notice it has these slotted holes here that'll let you hang or bolt a variety of objects to it.

And in the very center, they actually have 1/2 inch by 20 stainless steel insert that'll let you attach other SeaSucker products to the unit. It's threaded, so it screw right in there. Now the D-ring itself, you can see is a V shaped stainless steel D-ring. Let you hang or secure items with no drilling. And this is a hard plastic construction, very lightweight. It's only about a half a pound, yet very durable. Now it does include this protective cap that when you're not using it, you put that over the vacuum cup, make sure it's totally around it, and that'll help protect that vacuum cup from any hardening or cracking. So just like that, now you got it installed. Don't get any damage to it. You can see it is a nice bright white color. This part is made in the USA. Again, we mentioned the pull rating is 120 pounds. The diameter on this is 4 1/2 inches. The D-ring width is right about 2 1/2 inches. So again, just to demonstrate, just push down on it to start the vacuum, and then just start your pump. And again, as you pump it, you can see that that orange indicator will disappear. And now you're all ready to go. Simple as that. And the other thing is if this does slowly leak over time and that orange starts showing again, all you have to do is just repump it until it's not showing. And then again, to release it, just pull up on the side and it releases. But that should do it for the review in the SeaSucker 4 1/2 inch diameter vacuum mount with the stainless steel D-ring..