Replacement Driver's-Side Brake Assembly for Roadmaster Tow Dolly

Video Transcript for Ultimate Overview of the Replacement Driver's-Side Brake Assembly for Roadmaster Tow Dolly

Today we're going to take a look at the replacement driver's side brake assembly for the Road Master Tow Dolly. Now, this part will replace the driver's side brake assembly on your Road Master Tow Dollie. The Tow Dollie part number is RM-2050-1, we do sell that tow dolly separate on our website. This is just the brake assembly. This is a 10 inch by 2 and 1/4 inch electric brake assembly, and it is for the left side. The reason you can tell it's for the left side is you just look at the length of the pad on the shoe, this pad goes from here to here.

This one's all the way from here to here. The shorter pad is the primary shoe, and that'll always face the front of the tow dolly, so that tells you that this is going to go on the left hand side or driver's side.And the size, when they say 10 inch by 2 and 1/4 inch, the 10 inch would be the diameter from this shoe to this shoe. So if we put our ruler on there's your 10 inch, and the 2 and 1/4 would be the width of the pad on the shoe. There's you're 2 and 1/4 inches. Now these are electric brakes, so on the back you'll see two green wires, they do need to be connected.

One goes to the brake feed, the other goes to the ground, and are both green wires so you can use either wire for either function. These are manual adjustment brakes, they do need to be manually adjusted, and you do that by . see this adjustment hole at the bottom You'll put a screw driver or a brake adjustment tool through there, and you can turn this wheel and that'll adjust your brakes either in or out, whichever you need.Now this part number is for one left hand driver's side brake assembly, but that should do it for the review on the replacement driver's side brake assembly for the Road Master Tow Dolly.