Pollak Heavy-Duty Toggle Switch - SPDT- On-Off-On - 12 Volt - 50 Amp - 1" Handle

See what our Experts say about this Pollak Accessories and Parts

• Does Pollak Heavy-Duty Toggle Switch PK34218 Automatically Return to Center
  Nope, the switch does not automatically return to center after activating it with the Pollak toggle switch you asked about, which is the following part number: - Pollak Heavy-Duty Toggle Switch - SPDT- On-Off-On # PK34218 The toggle of the # PK34218 will stay in the position you switch it to instead of returning to center.
  view full answer...
• Troubleshooting Husky Brute Trailer Jack With Remote that Retracts Without Remote
  The Husky Brute Jacks like # HT87247 had some models with remote like you referenced. You may want to start by removing the battery from the remote in case it is actually giving a slow retraction signal. Although that is unlikely, it is worth a shot. The remote control panel is likely what is the issue or the physical switch itself allowing a slight power draw. The easiest way to disable the jack so it doesn't retract without replacing the component issue is to put a toggle switch like...
  view full answer...
• Will The HydraStar Electric Over Hydraulic Module Mess With Electric Brakes On My Other Trailers?
  Basically what the HydraStar Electric Over Hydraulic Actuator Adapter Module # HBA-CAM is doing is supplying more load/resistance when the brake controller is applying the brake signal to the trailer. This is essentially to fool the factory brake controller in your 2011 Chevy Silverado into thinking there actually are electric brakes and it is indeed needed for this purpose on your truck. From what I could find out, your factory controller can handle up to 8 brake assemblies (4 axles with...
  view full answer...
  
• Wiring a Switch to the Dash to Control Power to a Gate on a Dump Trailer
  For a switch to supply or remove power going back to the gate you can use a simple on/off switch such as # PK34213. This switch is rated up to 50 amp applications. For a switch that has 3 positions you could use on/off/on switch # PK34218 which is also rated for up to 50 amps. For wire you can use # 10-2-1, which is jacketed 2-wire sold by the foot. The flow of the power will go from the source (battery or alternator) to the input on the switch and then from the output terminal of the...
  view full answer...
• Switch Needed to Activate Up and Down Functions of Dump Bed
  For your application you need a switch like the Pollak Heavy-Duty Toggle Switch # PK34218 which has on-off-on positions and a 50 amp rating. Check to see which of your 3 wires carries constant 12V power and then use that one to apply power to the remaining 2 wires to determine which one is for the up and down functions. Once you know this (and you know that you aren't exceeding 50 amps) you will wire the up and down wires on either end of the toggle switch with the constant 12V power wire...
  view full answer...
• Toggle Switch Recommendation For 24V System
  I spoke with my contact at Pollak and they told me that part # PK34218 would be able to handle from 6 to 24 volt. They also told me that this has a 50 amp current capacity.
  view full answer...
• Would Toggle Switch # PK34218 Be Rated to Turn On Winch
  I wish I could say yes, but winches can sometimes draw a considerable amount of amperage and this switch is only rated for 50 amps. Some winches can draw up to 200 amps. What you can do is check the amperage draw rating for your winch and if it happens to be under 50 this # PK34218 would work.
  view full answer...

Do you have a question about this Accessories and Part?