Save Big with Cyber Monday Deals!
Replace the damaged plug on your power cord or create a new one with this 50-amp female connector. Cover slides off so you can attach wiring to the terminals. Twist-lock design provides a secure connection between your power cord and the RV inlet.
Features:
Specs:
Using the chart above, you can determine which type of plug is needed for your application.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today you're getting a look at how to wire the Mighty Cord Replacement Twist Lock Connector for RVs. This is the female 50 amp end. It's part number A10-50FDT. Don't replace your 50 amp power cord just because the plug is broken. Whether you've run it over or otherwise damaged it, it can easily be replaced with the Mighty Cord 50 Amp Twist Lock Connector. It's a weatherproof replacement with a rubber grommet to keep out dust, debris, and the elements.Now that we've gone over the features, I'll go ahead and show you how you can wire it up.
First thing you want to do with all electrical is unplug it and make sure there's no power running to it. For the other end, we've removed our damaged plug. I've cut back the jacket about an inch and a half, being sure not to cut any of the insulation. I've also stripped back the wire about a half an inch for each wire. Now we can set that aside and turn our attention to our plug.For this, you'll just need a flathead screwdriver.
You can start by loosening up the two flathead screws here on the plug. You don't need to take them all the way out, just loosen them up. Then you can pull it apart. With it taken apart, now you can unscrew the strain relief. By doing this, it's going to make it a little bit easier to connect our wires.
Now you can loosen up your connectors. The screws for those are located on the side. Again, we don't need to take them all the way out, just loosen them up.Now you'll want to bring your cable back in and slide on your cover. To make this easier, it's a good idea to bunch up the wires, and we'll just slide it on. You may have to twist it a little bit, and slide it on so we still have plenty of room to work with our wires.
Now, the connectors are color coded, so you'll just be matching color for color. The unpainted one is our black, so you can start there. It's a good idea to kind of clean up the copper a little bit. Now, when you slide it into place, you'll want to make sure that it's open. You can see on these two, they are not, so you have to push on them to open them up. You'll take your black and fit it into place. Once it's all the way in and there's no visible wire, you can tighten it down. You can attach the remaining wires the same way.After that's finished, you can reconnect your strain relief. It simply just folds back into place. You want to be sure you get it nice and secure, that way it can't become disconnected. Now you're ready to slide your cover back in place. There's a little notch just on the inside of the cover. You'll want to line it up with the channel here. Just take your finger, and you can feel for it just on the inside of the cover. Once you know where it's at, you can slide it back in place. Be sure you push it all the way on. Now you can retighten the last two flathead screws. I'm just going to get them both started. That way you can tighten them down evenly. Now you're ready to connect to your RV. Now you've had a good look at the Mighty Cord Replacement Twist Lock Connector for RVs, the 50 amp female end. Part number A10-50FDT.
Average Customer Rating: 4.9 out of 5 stars (33 Customer Reviews)
Replace the damaged plug on your power cord or create a new one with this 50-amp female connector. Cover slides off so you can attach wiring to the terminals. Twist-lock design provides a secure connection between your power cord and the RV inlet.Good construction, but took some doing to match my Furion 6 AWGN supply line. Wires in cable were not sequenced to match the respective slots in the plug, so I had to remove more outside cord insulation than I wanted to make it work.
It’s is a quality part and the shipping is super fast. The part and shipping saved the weekend. I highly recommend this product. It’s a fraction of the cost of new cord.
Clyde - 08/21/2022
This is a great replacement part if you break the original piece like I did. Truly clear instructions provided. Study the piece you remove to get the electrical wire hooked up correctly.
It was hard to get the cover back over. I had to over tighten the screws on the cord retainer, distorting the cable severely on 50amp 1" cord.
Exact replacement - went together easily
Perfect for wiring you own 115V/20amp service to the 220V/50Amp RV Twist Lock. Too many dog legs adaptors are hard wired with 'curious' output/ohm readings.
Quality product that did the job.
Products arrived today on Friday, 3 days earlier than expected...GOOD JOB!!!! I realized when opening shipping box that I had ordered the wrong parts for my electrical cord and called E-Trailer and talked with Jesse who helped me get the right parts that I need and they will be shipped to me soon, when all parts are there to ship. It sure great to find a company that is customer friendly. Will be ordering more in the future and will recommend your company to other campers in the future.
Herman S - 05/05/2018Excellent plug. When you use it with the A10-50FTD cover with threaded ring, provides a water tight connection.
John - 07/01/2019Product has held up very well and I use it a lot. This is the main power cord for our BBQ trailer so it is very important that it keeps working.
Everything was shipped on time with all items in box. ETrailer made sure everuthing was satisfactory from the order process all the way to receiving it.
Thank you guys!
I have been using the plug on my trailer of a year. It was easy to install.
product as advertised Fair price with good shipping.
would buy from etrailer.com again
Just finished putting this on my 50 amp 4 wire power chord. Easy install, works great.
works good so far
Exactly why I needed to repair my good! Excellent customer service!
was a little tight to fit over the cord so I used some dish soap on it and it slid right on. Definitely weather tight.
Excellent product works perfectly
Great price, awesome customer service
Great product. Just as needed.
Excellent product, just what I needed....arrived as requested.
Price was right, product great!
I got my part today and it works great thank you
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.