This replacement control module is the brain that enables your single, double, or triple electric Lippert Coach Step or Stromberg Carlson sliding step to function properly. It attaches underneath the step's base with 4 screws (not included).
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the Replacement Control Module for an Electric Coach Step. This replaces the control module that came standard on your single, double, or triple electric Lippert Coach Step, or Stromberg Carlson Sliding Step. This unit simply houses the circuits and electrical components necessary for the step to function properly. It's going to include the weatherproof wiring and connectors. It installs underneath the base of your step with four self-tapping screws. The screws are not included, but when you're ready to install this, you'll remove the self-tapping screws holding the ground wires on your previous module. Then you'll need to disconnect the four pin connector to the motor wiring harness, that will look just like this one.
Disconnect the two pin connector to the motor, it's going to look just like this one. Remove the self-tapping screws holding your module in place, and simply install the new module in reverse order. A few measurements to go over with you real quick and then we're going to go over a few of the wire functions. Edge to edge going this direction, it's going to give us a measurement of 5 13/16". Going this direction, just measuring the box portion, that's going to be 4 1/8". The holes are separated on center going this direction by 3 1/8", and the hole separation on center in this direction, is going to be 5.25". Really nice design.
Again, you're going to have your four pin connector, goes to the motor wiring harness. Two pin connector that goes directly to the motor and then your black wire right here, this is going to be the wire that gets connected for the step light. You're going to have two green wires, these are both ground wires. One grounds the chassis, the other one grounds to the steps. Then your purple wire, located right here, this is going to be for the step light switch.
That's going to do it for today's look at the Replacement Control Module for an Electric Coach Step. Again, this replaces the control module that came standard on your single, double, or triple electric Lippert Coach Step or Stromberg Carlson Sliding Step.
Average Customer Rating: 4.9 out of 5 stars (85 Customer Reviews)
This replacement control module is the brain that enables your single, double, or triple electric Lippert Coach Step or Stromberg Carlson sliding step to function properly. It attaches underneath the step's base with 4 screws (not included).Excellent service from etrailer. Did not receive any directions with this product but contacted your help line. FYI if switching from an older SCS/Frigette step control with 9 wires to the newer 10 wire model. Connect the black bare end wire to steplight. Purple wire with bare end does not have any application on my motorhome so just capped it off. Would definitely order again from etrailer. 177806
So far this controller is working well. I deducted one star since the previous controller I purchased lasted less then two years. Hopefully this one will make it a good bit longer. 706206
Product arrived on time. I reviewed the video and installed in less than an hour. Wonderful service. Recommend highly. 552181
Got the step controller for my 2007 Dutch Star. Easy installation. Everything lined up. Screw holes and wiring. The black wire for the light ,which I had read on a review and the purple wire not used. Step back operating normal. Could not have asked for anything better. The service was great, product great. Glad to have found these people to deal with. Thank You 653418
Product arrived well packaged and sealed in plastic. The unit is an original Lippert component. It was free from defects and functioned properly upon installation. The inclusion of a wiring diagram would've made installation he's here and able to proceed with confidence. It's absence however is not that limiting in that the connections are somewhat intuitive. The etrailer ordering process was easy and they shipped my unit without delay. A quality product from a quality company. Tip: when trouble shooting a motorized RV step, don't forget to check the integrity of the magnetic door switch. 547583
The control module for the electric step on our RV stopped working because it became corroded from sprayed sand and water. The new unit is much better designed and fully insulated against a repeat of the problem. It works very well and was delivered as promised. I am pleased with the service. 404905
Don S - 08/01/2018Ordered this while on the road. Great service from etrailer, Brian took order and shipped to my next location where it was waiting for me. New unit bolted and plugged right in, works perfectly. Old controller failed after 10 years exposure to wet roads covered with corrosive crud. New controller is fully potted in rubberized compound which completely seals electronic parts from the elements, rather than old style conformal coating, so new unit should be more reliable. 484690
Installation went smoothly, steps open and close just like new. 798763
works great, eTrailer said it was in stock but took 5 days to process the order so I had to wait 12 days to receive my part. Sloooow 797005
Part was exactly what I needed 785279
I have a 2005 Newmar Dutch Star and the step started acting up last year. Sometimes it would not close or open when it should. Then all of a sudden it would operate. I ordered this part. It was an exact replacement, just looked sealed better than the factory one. It had a few ground wires, 2 connectors and a black wire I connected to the step light. I did not use the purple wire I tightened everything up with a few wire ties, cleaned up all of the ground connections. And finally I added some dry lube to all the moving parts of the step and pivot points. I closed the door and it was like new. Cycled the door and few times and it worked perfectly. My step was manufactured by Coach Step Inc. Part Number 725-0022 Step Assy. If you are having step issues I highly recommend this item. Easy to install and works great! 773817
Easy. Quick. Knowledgeable. Thx guys!! 773416
Fast shipping, fixed our problem. Thank s! 764470
It wasn't the same as what came on the motorhome but fit and works real good. Thank You 763100
Great web easy to use part is as advert ised. 762981
We are a repair center installing for a customer 745985
One year later and my steps work perfectly with the new parts from Etrailer. Highly recommend them and their staff for all your RV parts needs. 724642
Satisfied with product, sometimes it seems to get out of sync , but works when cycling on and off. 717478
This controller for our class A RV step has worked flawlessly. It was a direct replacement for the original, so no modifications for installation were required. We had been experiencing erratic operations, sometime it wouldn't go out and other times it wouldn't go in. It's been almost a year since it was installed and does what it is supposed to do, every time. 710968
Thank you for your wonderful Customer Service! Always above and beyond. 707148
Worked great! 703721
Simple plug and play. 678402
Product works as if or like new. 662602
great product easy install and works as it should 655502
Plug and play. Saved my steps. And the product seems to be well made . 629392
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.