In-stock alternatives that are ready to ship
Drive-in wheel stud is designed for Kodiak integral hub-and-rotor brake assemblies. Works with 8,000-lb, 10,000-lb, 12,000-lb, and 14,000-lb hubs. Bolt is 3-1/8" long and has a thread size of 5/8"-18 UNF-2A.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Kodiak replacement driving trailer hub wheel stud. 5/8" diameter by 3 1/8" long, and a quantity of one. This 5/8" stud is designed to replace a damaged wheel stud on your trailer hub. The raised spline portion right down here on the stud is what will be driven or pressed into your trailer hub, and the stud is what will go through the bolt hole on your trailer wheel when you put your wheel up on your hub, and when it's used with a heel lug nut, will hold your tire wheel to your axle. These bolts are grade eight. They are stamped on the head. The thread size in is 5/8" diameter and it's 18 threads per inch.
They do use 5/8 by 18 size lug nuts. I did happen to pull one from our stock here just to show you. Once this is on your trailer hub installed, then you put your wheel up on stud and then tighten your lug nut down. Torque it to the correct spec to hold your wheel and tire assembly to your trailer. This size lug is normally used on 16" and larger wheels. The overall length is measured from the bottom of the head to the very end of the bolt.
This one is going to be right at 3 1/8". The threaded portion length is going to be right at 2". Then the spline diameter, this is the portion that will get pressed into your hub, the diameter on that is 11/16". That should do it for the review on the Kodiak replacement driving trailer hub wheel stud. 5/8" diameter, 3 1/8" long and a quantity of one.
Average Customer Rating: 4.7 out of 5 stars (6 Customer Reviews)
Drive-in wheel stud is designed for Kodiak integral hub-and-rotor brake assemblies. Works with 8,000-lb, 10,000-lb, 12,000-lb, and 14,000-lb hubs. Bolt is 3-1/8" long and has a thread size of 5/8"-18 UNF-2A.
I own a repair shop so I use your parts all the time , saying that it never returned so all I can say is it must have worked.....
THANK YOU FOR CARRYING THIS!
As advertised, quality product, prompt delivery, Thank you !!!
Great service
Hope they are correct!
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.