InfiniteRule Lock Set for Gen-Y 10K and 16K Ball Mounts for 2" Hitches - Qty 3

Video Transcript for Review of InfiniteRule Ball Mounts - Hitch - 34061650-D

Today we're going to take a look at the InfiniteRule Lock Set for the Gen-Y adjustable ball mounts for two inch hitches and it's for a quantity of three locks. Now these are flushed out locking pins that will replace the standard pins for your Gen-Y 10,000 pound or 16,000 pound adjustable ball mount. The sharp pin right up here, this will secure your ball mount to your two inch trailer hitch. Along one of these long pins will secure your ball platform to the ball mount and then the extra additional long pin will secure your Pinto hook or other accessory to your ball mount platform. These are a heavy duty, rust resistant, stainless steel construction. On the inside, when you remove the head, they have an O-ring on there to protect the internal components from letting any dirt or grime get on the inside.

And if you notice on the end they have these rubber, weather resistant, tethered dust covers, which will keep your water or debris out of the key way.These are all keyed alike, comes with three keys and they are made in the USA. And just to show you how to install the lock, you put your key in there and then you just loosen it like you're unscrewing a bolt. And it'll totally take the head off. There you can see the red O-ring there that'll help seal it, keep any dirt or debris from getting on the inside. And then once you install your pin, put the head on the other end.

And then with your key you just twist it like you're tightening it. And then once you get it tight, just snug it down, back it off just a little bit. Pull your key out, put your cover on, and then you're locked and set all ready to go.Again. The specs on this, the application is for the Gen-Y 10,000 pounds and 16,000 pound adjustable ball mounts for two inch hitches. And it will also fit the Gen-Y 32,000 pound 1700 series ball mounts.

These locks have a sheer strength of 42,000 pounds and the sheer strength pretty much is determined by placing the . They placed a locking pin in a stress position and then subject it to increasing force until required proof load is either met or the pin fails. Each one of these locks has exterior strength of 42,000 pounds.Pin diameter on the locks are five eights of an inch and we'll give you some measurements. We'll start with the short pin. Overall length on it one end to the other is right at five and a quarter inches.

The inside pin length of the span is two and five eighths inches. And the dimensions on the two long pins, the overall length end to end is right at five and three quarter inches and the inside pin length or span is right at three and one eighths inches. And again, it is for a quantity of three locks and three keys, but that should do it for the review on the InfiniteRule Lock Set for the Gen-Y adjustable ball mounts for two inch hitches.