Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replace your trailer breakaway device with this durable switch kit that features a coiled cord. No more dragging or fraying. No need to wrap cable around your trailer frame.
Features:
Specs:
Similar to FA80-00-2040
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today you're going to get a good look at and we're going to show you how to install the Fastway Zip Trailer Break Away Switch with coiled cable. It's available in four foot long with part number FA80-00-2040 and in six foot with part number FA80-00-2060. This is a great replacement for your trailer's old break away device. In case of a catastrophic event where you may become uncoupled or disconnected from your trailer, this switch will activate, locking your brakes, bringing your trailer to a slowing halt.The cable is coiled to prevent it from dragging on the ground. It doesn't look thick, but it's actually a high strength woven steel, so it's going to be durable and last for a long time. The vehicle end features a carabiner so it's easy to connect to your safety chain loops.Here at my camper, you can see my old break away switch is junk.
It's just hanging there. We're going to replace it with the Fastway Break away switch. Yours may remove differently, I'm just going to unbolt mine and cut my wires. Now, on this trailer, the wires are run through some loom. I'm just going to reveal them and then cut them where I want to splice into them.
Now I can remove and discard my old break away switch.Now you can set your break away switch in place where you want it. You want to be sure you have enough room to connect your break away to your vehicle. To get it mounted, you'll have to provide your own hardware. We recommend using a self-tapping screw.I've gone ahead and routed my wires through the wire loom material, back to where I cut my wires. If you don't have any loom material and would like some to protect your wires, you can pick some up here at etrailer.com with part number 459075-1, and that's sold by the foot.
Here where my wires meet, as you can see, I've got some excess. I'm going to trim some off. I'm going to be using some butt connectors, so we'll want to be sure and allow for that.Now I'm going to strip back all four of my wires with some wire strippers and I'm going to go back about a quarter of an inch. We'll be using heat-shrink butt connectors. These are not included, but you can pick some up at etrailer.com with part number DW05744-5.
Now since it's a switch, it doesn't matter positive or negative, we can connect either wire to either wire. So we'll first take our heat-shrink butt connector and make sure that that's all the way inside, then I'm going to crimp it. And I'll take one of my other wires and do the same thing. Then I can repeat the same process with my other wire.The reason we're using heat-shrink butt connectors is because we're on the outside of the trailer and we don't want any moisture to get inside. Let's go ahead and shrink those down. We're using a heat gun to do so. Now we'll tuck our wires back into our loom. If you want, you can use some electrical tape.To test it out, you can support one of your axles with a jack stand, then you can get your wheel spinning real good and then have somebody pull out the switch. Go ahead. If it locks up, it works correctly. And now you've had a good look at, and you know how to install, the Fastway Zip Trailer Break Away Switch with coiled cable.
Average Customer Rating: 4.7 out of 5 stars (77 Customer Reviews)
Replace your trailer breakaway device with this durable switch kit that features a coiled cord. No more dragging or fraying. No need to wrap cable around your trailer frame.Replaced original breakaway switch and cord with this one. Took about 10 minutes to wire up and install.
The new breakaway switch works great.
Etrailer had the best price on this switch and cable. I like the coiled cable. It is neat and stays up out of the way. I had my old steel cable catch the hitch and pull the pin on the breakaway switch. This cable should eliminate that problem. My only complaint is I paid extra for 3 day shipping. It took four. Wouldn't have been a big deal normally but I was waiting on it to leave on a trip.
Not installed yet but looks to be a quality piece. Should do exactly what was promised.
Neat and easy to install. Fortunately I have not encountered a breakaway.
The coiled cable makes the breakaway switch easy to attach quickly without having to figure out what to do with the extra cable that often drags on the ground. Much better design.
Just what we needed.
Everything arrived in perfect condition. The Barman 92 series replacement lens was a perfect fit for the light on our 1999 Coleman camper.
The Fastway Breakaway switch with it's coiled cable is a welcome relief from the switch on the camper now. I haven't installed the hand held shower unit, but it looks as though it will fit perfectly. My only very small issue was in boxing the items. Packing the box a little tighter maybe would have prevented the slight damage to the box.
I would definitely recommend and use etrailer.com in the future.
I have received the new breakaway switch and it looks great. Unfortunately I will have to wait to install it as the trailer currently has approx 4 foot of snow on it and it's "out back" meaning I have a couple hundred feet of 4-5' high snow to go through to get to it. In addition we are in the midst of a deep freeze. Current temp is minus 7 degrees! I will install the unit most likely in late March or even April
I installed all the products that were purchased from etrailer.com with the assistance of the videos. It was helpful and it saved me from having to pay someone to do the work for me.
etrailer.com is a great website to purchase all one's needs for towing equipment.
Thank You
The sping coiled wire was the perfect addition as it keeps it out of the way when the trailer is stored and can reach the different connection points on my truck and motorhome.
Thanks etrailer!
This was purchased as a replacement for the original which had seized up. The coiled cable is excellent. The original required taped up coils in the cable to prevent dragging.
One year later, still in service. Excellent replacement when my drivers break one.
Get rid of that old cable type and get something like this that recoils when you disconnect it. Don't know if the clip will survive a winter of salt. Should be stainless steel to survive
Excellent product and fast shipping, easier than looking all over town for the product and the prices are better. Thanks etrailer
Installed easily enough and hope to never find out if it works in real life. The switch does function as designed.
Greg
1/17/2021
A year in and I have not had a breakaway but, it is still attached to the trailer and used every time I hook up. Perfect in my opinion.
Not much to review here. Product looks as shown, works as expected.
Just a simple breakaway switch. Haven't had an issue with it in the year
that I've had it. Price very reasonable, delivery reasonable as well, and
within an expected time frame.
Product delivered fast and was easy to install and works great!
Monty
6/17/2019
Product was easy to install and still working great after 1 year!
This coiled cable and caribeaner is a great idea and item. The breakaway coiled cable keeps it up and out of the way. Looks and function are much better.
Super fast shipping!
Well made product that arrived in a timely manner.
AGAIN' BEST PRICES OVER THE WEB.
well i can not test this till the 1 first week of aprill ,so i would think it ok ,iam in quebec and ordered thought my mother in law (snow bird comming back end of the mouth,
but must say for for sevice and Price and allso for information and detail on items TOPS!, Best place i found on google to order .
Great quality at an affordable price. Plenty of wire to meet any configuration/setup.
The breakaway switch looks very well made. Did not have chance to install it or try it yet.
ANOTHER EASY INSTALL. GOOD QUALITY CABLE THAT DOESNT RUST OUT AS OF YET (1 YEAR LATER) I CANT TELL YOU HOW GOOD IT WORKS BECAUSE I DONT WANT TO FIND OUT HONESTLY.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Pete D.
4/15/2017
This switch and cable has been trouble free.