This 1/2" temperature and pressure relief valve helps protect your RV's water heater from excessive temperature and water pressure. The 4" long, epoxy-coated metal probe resists corrosion. Factory set at 150 PSI.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi there RV and camper owners. Today, we're going to be taking a look at Camco's water pressure relief valve. This water pressure relief valve has a half inch inlet and outlet, and is designed to protect your pipes in your trailer or RV from an over pressure or an over temperature condition. The relief valve is set at 150 psi. So in the event that the outlet of your water heater is exceeding that, the valve will open and it will dump that excess pressure out through the hose that we've routed down underneath our RV. You will have to purchase the additional hose and potentially an adapter to get it attached to get it all set up, but you can get those at your local hardware store.In addition to protecting your system from an overpressure condition, it also protects it from temperature.
There's a four-inch probe that comes off of it to detect temperature, and it's designed to relieve any excess pressure once it hits about 210 degrees Fahrenheit, because at 212 degrees, that's when boiling occurs. And once the water starts to boil, pressure is going to rise very drastically. So it wants to stop that from occurring before it gets there. While many of the tank water heaters have relief valves made into them, a lot of your tankless units don't. And if you just replace one and you don't have a relief valve, you really want to add one to your system as a safety precaution.In the event you didn't have one, once the pressure gets to a certain point, your pipes can only hold so much pressure, and at that point they're going to burst.
And you don't want hot water bursting out potentially on you or on any of the items in your trailer or RV. On this particular trailer here, we just got done removing the tank water heater and replacing it with this tankless unit, which is going to be more efficient and it's also going to ensure that they never run out of hot water unlike that tank unit which would runs out usually after one person takes a shower.With this, we did have to buy a couple of additional components. A T here to put it in line with the outlet for the hot water. But once it was installed, at this point now we are protected from over pressure and over temperature for our system so we don't have to worry about any expensive repairs in the future or anybody getting a potential burn from over pressure or over temperature. The metal has an epoxy coating on it, which is going to protect it against corrosion so you can have long lasting operation of your valve.
When installing this on many of your metal to metal contexts, you do want to use some thread tape to ensure it seals. You can get some Valterra thread tape here at etrailer.com. And that completes our look at Camco's water pressure relief valve.
Average Customer Rating: 4.8 out of 5 stars (44 Customer Reviews)
This 1/2" temperature and pressure relief valve helps protect your RV's water heater from excessive temperature and water pressure. The 4" long, epoxy-coated metal probe resists corrosion. Factory set at 150 PSI.They have good product knowledge & fast service.
Haven't ever had it trip in use, I flip it manually after every camping trip to release any remaining pressure.
4" probe is not compatible with the Fogatti RV Tankless Water Heater we purchased, I added a 2-1/2" riser to the heater to make this work. (Parts for my camper aren't available locally (closest RV repair is 100 miles away, and they always have to order anything I need) no local plumbing service had anything shorter either and needed this repair completed the day it arrived).
It's doing its job. And always fast shi pping
Carol and the whole Group at etrailer were fantastic to deal with. Being a newby to the RV world, everyone was extremly helpful and understanding. Even when i had a manufacturer issue with a part they stayed on the manufacturer until THEY got satisfaction, how many companies are out there that will stand behind thier products like that? My experience has created a customer for life and a moving billboard at that :)
Easy install, perfect fit, and for those campers, you better consider replacing the hot water pressure gauge on the tank, even if it looks okay. I replaced mine from etrailer.com
The water heater works great. Now we can take a shower without running out of hot water
ease using the website and the delivery was quicker than anticipated
Great price for great product.
Love shopping your store! You have had two items that we needed this summer for our camper. Now our water heater doesn't leak any more! Thank you!
Great water heater valve. It’s a perfect fit!
Always a pleasure working with Etrailer
Thank you etrailer.........
perfect fit and looking forward to using the HW heater.
Thank you Very much your product is excellent and I appreciate it your fast delivery
Item was as described, and it’s doing it’s job. Speedy delivery as well.
Super fast delivery
I rate product with five star it was right fit works great and shipping was quick......
I appreciate your service and response time. Thanks
good quality
I received my order on time, I will be using this company again for all my camper needs. Very professional, prompt and courteous.
Excellent service !!!
Exactly what I needed.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.