Heavy-duty replacement bracket works with another 90-degree bracket (sold separately) to stabilize one end of an extra-large bunk board on your boat trailer. Installs on level trailer frames with a U-Bolt (sold separately).
Features:
Specs:
Galvanized Steel
Galvanized steel parts are hot-dipped in zinc after being stamped. This creates a coating that is typically 3 mil to 5 mil thick. This thick, all-around coating allows galvanized steel products to provide years of use without rusting or corroding.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the replacement CE Smith heavy duty vertical bunk bracket. This is replaces one damaged CE Smith heavy duty 90 degree vertical bunk bracket on your trailer. It stabilizes one end of the bunk board when used with an additional bracket, 90 degree angle is for vertical mounting onto a level boat trailer frame. It does require 1/2" U-bolts for installation. U-bolts are sold separately, if you're in need of that type of hardware you can find them here at etrailer.com. This does require again 1/2" diameter U-bolt.
It's constructed of rust and corrosion resistant galvanized steel, suitable for saltwater exposure, approximated right here in the USA. A few dimensions to go over with you real quick, starting with the width of the unit. Edge to edge, about 5", overall height bottom to top we're looking at about 8". Distance between the bunk board mounting holes, you can see that all of those are going to separated on center by 1-1/2" apart from one another and then the distance that we have between the trailer mounting holes, again on center, we're looking at about 3-9/16". Then the plate thickness is going to measure 1/4" that's going to do it for today's look at the replacement CE Smith heavy duty vertical bunk bracket.
Average Customer Rating: 4.5 out of 5 stars (2 Customer Reviews)
Heavy-duty replacement bracket works with another 90-degree bracket (sold separately) to stabilize one end of an extra-large bunk board on your boat trailer. Installs on level trailer frames with a U-Bolt (sold separately).These bunk braces far surpass anything I purchased in the past. These braces are 1/4” galvanized steel plate and match perfectly with the U-Bolts also purchased at the same time. I’m very pleased with these products, as with all products I’ve purchased to date.
Part was a perfect replacement, my only comment would be that I had to ream out one of the holes that had an excess galvanizing partially blocking the u-bolt from passing through.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.