Replacement Incandescent Bulb for Bargman Tail Lights - 1156 Single Filament

Ask the Experts about this Bargman Accessories and Parts
Do you have a question about this Accessories and Part?

• Replacement Light Lens and LED Elements for Optronics Dual-Face Trailer Light ST52AA
  
• Yes, we do sell a replacement amber lens for the Optronics Dual-Face Post-Mount Trailer Light # ST52AA that you referenced. The replacement lens part number is # A52AB. We also offer a replacement type 1156 incandescent bulb, part # 30-90-156. But if you'd like to convert this incandescent light over to brighter and more-efficient LED operation you can do this easily by substituting an LED element for the 1156 bulb. LEDs use much less power, create less waste heat, are brighter and...
  view full answer...


• Does Bargman Tail Light w/ Backup # 30-92-002 Come With Sockets and Bulbs and Instructions
  
• The inside of the Bargman Surface Mount Tail Light w/ Backup, part # 30-92-002 has two sockets with two bulbs. The top bulb is a # 30-90-156 single filament bulb that is for the reverse light. The bottom bulb is a # 30-90-157 double filament bulb that is for the tail light functions. I went out to the warehouse and took the lens off of the unit and took a picture that will show you what the inside looks like. I have attached the picture for you to see. The Bargman light does not come...
  view full answer...


• Replacement Rear Lens and Bulb Needed for 2013 Aliner Ranger 15 Pop Up Camper
  
• I have included a link to all of the replacement bulbs that we offer for the 1156. You can use the filters on the page to narrow your search. For replacement LED bulbs in red, you can use Putco Plasma, part # P241156R-360. As for a replacement lens, even after speaking to my technical contact at Bargman, we were not able to locate any information for the 110420A number that you provided. If you could send me a picture of the light and any other information that you can obtain from the...
  view full answer...


• What is the Power Draw of the Optronics RV Ceiling/Wall Light # RVSL21
  
• The Optronics RV Ceiling/Wall Light, # RVSL21, will draw 1.4 amps at 12-volts. The light bulb in the Optronics light is a standard 1156 automotive bulb, like # 30-90-156. Typically this bulb as a Watt rating of 25W.
  view full answer...


• What is Power Draw for Optronics Trailer Dome Light Using Incandescent and LED Light Bulbs
  
• An 1156 incandescent bulb, like # 30-90-156 that is in the Optronics Trailer Dome Light # IL91CB draws between .5 to over 2 amps. If using an LED bulb in this light, like part # AR50387, the draw is 0.301 amps.
  view full answer...


• Are LED Replacement Light Bulbs Available for SAE-AILRST 94 DOT Bargman RV Lights
  
• To replace your light bulb you will need to use a 1156 or 1157 light bulb like part # 30-90-156 or part # 30-90-157 which are incandescent options. We do have replacement LED bulbs in this size which I have linked for you to filter through. I did speak with my contact at Bargman who informed me that not all LED designs will work properly with your tail light cover dues to cover and light bulb design. They could not make a recommendation other than using Bargman incandescent light bulb...
  view full answer...


• Replacement Bulb for the Optronics Light part # IL21CB
  
• I went and pulled a Rectangular Weatherproof Interior and Exterior Trailer Utility Light with Switch # IL21CB from our warehouse and took it apart and found that the bulb style you would need for a replacement would be the 1156 style bulb. We carry this bulb, check out part number # 30-90-156.
  view full answer...


• Different Types of Light Bulbs Used in Trailer Lights
  
• I do have options for you but there would be no way for me to know what type of light bulbs your trailer lights use. For trailer lights there are generally two types which are bayonet or push-in. Most taillights use a 1156 or 1157 bulb like part # 30-90-156 for single filament or part # 30-90-157 for dual filament. If your taillights have multiple functions for one bulb then you will need a dual filament light bulb. Marker or clearance lights on the other hand could use a variety of...
  view full answer...


• Replacement Bulb for Rv Scare light item # RVSL21
  
• The # RVSL21 Scare light uses an 1156 replacement bulb that is widely available. We carry this bulb also, part # 30-90-156. These bulbs have two posts that slide into slots in the socket and then you turn the bulb approximately 1/4 to 1/2 turn to lock it into the socket. There should be 2 wires going to the bulb socket. One will attach to the bulb base for ground and the other will attach to the center of the base at the bottom for power to the bulb.
  view full answer...


• Are Load Resistors Required to Replace 1156 Bulb with LED Equivalent for Backup Light Use
  
• The Bargman 84-85 Series Triple Tail Light # 47-84-530 uses a single filament 1156 incandescent bulb like # 30-90-156 that can be replaced with an LED like # AR50387 or # CM93226. A load resistor is NOT required for this application.
  view full answer...


• How to Remove Broken 1156 Light Bulb
  
• The Sylvania 1156 bulb inside your tail light should have two small tabs at the bottom of the bulb that you will need to first align with the grooves in the light socket. Once the tabs are aligned, you should be able to just push it in, twist it a bit, and the bulb will come out. If the glass is broken, I recommend using the traditional potato method. Cut a potato in half, firmly press it against the socket and begin twisting it in this manner. We do have a replacement 1156 single filament...
  view full answer...


• Does the Trailer Dome Light with Stainless Steel Base Run On a 12 Volt System
  
• Yes, you can run 2 or 3 of dome light # IL91CB off of a 12 volt battery. This light was designed to work on a 12 volt system so you will be good to go. This light uses an 1156 bulb, # 30-90-156, which is readily available.
  view full answer...


• Replacement Taillight Bulb for 2009 Casita Freedom Deluxe
  
• Yes, I looked up pictures of your 2009 Casita Freedom Deluxe and it uses a Bargman 84 series light so you would need a 1156 replacement bulb like part # 30-90-156.
  view full answer...


• Recommended Replacement Bulb For 1990 Coleman Plantation Popup Tail Light
  
• I did some research and tried to find more information so that I could recommend the right bulb. I did not find a specific match but similar tail lights in our available inventory use some replacement bulbs by Bargman which might work for you. I recommend two bulbs by Bargman: Incandescent Bulb for Tail Lights-Double Filament (Item # 30-84-057) or Incandescent Bulb for Tail Lights-Single Filament (Item # 30-90-156). I am sending pictures of these bulbs that will help you confirm whether...
  view full answer...


• Options for Amber Trailer Exterior Lights
  
• The LED Porch Light # DG52526PB that you referenced uses multiple LEDs (27, in fact) that are not replaceable with an amber LED element like # 11562-S24SMD-A. The lights that you purchased, parts # RVILL33 and # RVILL34, also do not have replaceable elements. The LED "bulbs" are made for replacing many popular standard incandescent bulbs; this one replaces an 1156 bulb type like # 30-90-156 which is fairly common in RV aplications. You could install a new light made for an incandescent...
  view full answer...


• How To Remove A Stuck 1156 Light Bulb
  
• In order to remove the Replacement Incandescent Bulb for Bargman Tail Lights part # 30-90-156 you will need to first align the two extended tabs at the bottom of the light bulb with the grooves that correspond to those tabs in the light socket. Once aligned, you can then push in, twist, and pull the light bulb out. It may be necessary to use a bit of electrical connection cleaner to free any dirt or corrosion from inside the socket that may be causing the bulb to be stuck in place.
  view full answer...


• What Type of Bulb is Used in the Optronics Dual-Face Post Mount Light ST52AA
  
• I pulled the Optronics Dual-Face Post Mount Trailer Light, # ST52AA, and it uses a 1156 bulb. For a replacement bulb, you can use part # 30-90-156.
  view full answer...


• Replacement Reverse Lamp Bulb for 2013 Ram 1500
  
• We've got just the bulb you're looking for. The reverse lamp in your 2013 Ram uses a 921 wedge type bulb. For a plain 'ol replace what's there choice, go with part # 30-90-021. We have it listed as a trailer taillight bulb, but its the same bulb and would work just great for you. For an LED version that would be brighter, use less power and last longer, you could go with part # DG52609VP.
  view full answer...


• Wiring a Powered Modulite Power Wire and Backup Lights on a 2007 Mazda 5 Towing a Trailer
  
• If the dealer hooked up the trailer wiring harness on your vehicle then they must know of a circuit that provides enough amperage to power trailer lighting and not affect the vehicle wiring in any way, if there is an over draw or short. We recommend that the power wire from the Upgraded Circuit Protected Modulite, item # 119179KIT, be connected to the vehicle battery positive post to eliminate any chance of damaging the sensitive circuitry on the vehicle. If you need to install a 5-Way...
  view full answer...

Do you have a question about this Accessories and Part?