How To Choose Correct Replacement Stabilus Lift-O-Mat Strut for RV Awning

Question

Question:

I am looking for a Stabilus Lift o Mat gas spring to replace a bad one on my trailers awning support arm. Do you sell just the gas springs?

asked by: Tim M

0

Expert Reply:

I might have an option for you but we don't carry Stabilus Lift-O-Mat. That said, we do offer replacement struts for certain awnings such as the Solera Pitched RV Awnings part # LC260282 or the Solera Flat RV Awnings part # LC280343. If you can let me know which exact awning you have I'd be glad to confirm if we have a replacement strut.

expert reply by: Conner L

0

Answer 1

I was able to find the 126003 hub and was able to determine that it is a 3,500 lb hub/drum with a 5 on 4-1/2 inch bolt pattern just like the #AKHD-545-35-K that you referenced. This hub will work as a replacement for your Lippert.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Dan, for your 2024 Ford F-350 that has the OEM pucks the correct Pullrite sliding hitch you need is the part #PUL73RR. The #PUL63RR fits the standard above bed fifth wheel rails that are 22 inches apart on center. What fifth wheel do you have?

view full answer...

Answer 5

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 6

It looks like you ordered both from us today to use with your Carrier lower vent assembly. The heat strip will work with the Advent but if I am being perfectly honest a lot of times these mixed brand AC Unit solutions don't work as consistently…

view full answer...

Answer 7

I did some checking and it appears that the gas strut #LC260282 is held to the support arms with bolts, pins, or rivets that go through the eyelets at each end, see picture. It does not appear that the strut unscrews from those eyelets. The…

view full answer...

Answer 8

The Power Gear motor 383909 is no longer available but when I reached out to my contact at Lippert he said that it was replaced with the Gear Motor Assembly DSMX with P Connector for Lippert Componenents Slide-Out #LC368190 so that is what you want…

view full answer...

Answer 9

We have replacement support arms from Solera that measure 69 inches such as the Solera 69" Standard Flat Awning Support Arm #LC281154 (Black) and Solera 69" Standard Flat Awning Support Arm #LC281152 (White) but no replacement arms that are…

view full answer...

Answer 10

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 11

Based on the info I was able to find for your awning strut the replacement you'd want is the part #LC260282.

view full answer...

Answer 12

Everything I can find on that part number indicates it is from a Carefree awning. We only have replacement struts for Lippert awnings which are #LC260282 and #LC280343. I would try checking with Carefree to see if a replacement is available. If not,…

view full answer...

How To Choose Correct Replacement Stabilus Lift-O-Mat Strut for RV Awning

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching