How To Replace The Heating Pad In A Thomas Payne Seismic Recliner

Question

Question:

We watched the video on YouTube on how to change the heating pad on our recliner. They make reference to a zipper on back edge of cushion. We do not have a zipper anywhere around cushion. How else are we to replace the pad without a zipper? Thank you for your help.

asked by: David R

0

Expert Reply:

You will have to go from the side or underneath. Then you can unplug and remove the old pad and replace it with the Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs # 674864.

If you need to replace the entire kit you can use the Replacement Seat Heater Kit for Thomas Payne RV Furniture # 195-000113

expert reply by: David B

0

Answer 1

Thomas Payne does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced but it's more or less disassembling the couch cushions to access the pad, unplugging and remove the old heater and reversing…

view full answer...

Answer 2

Lippert, who make the Thomas Payne line of furniture, does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced. Installing this heating pad requires more or less disassembling the couch cushions to…

view full answer...

Answer 3

I cannot recommend you alter the location of the heating pad on the Thomas Payne Seismic Dual Power Reclining RV Loveseat. That said, if you do not wish to have the heated seat feature this can be turned off via the controls on the cup holder. If you…

view full answer...

Answer 4

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and under…

view full answer...

Answer 5

As you have no continuity on the Heating Element #674864 they are bad. It makes me think as they both went out at the same time you may have had a power surge which caused damage to your seats in your camper. If you do not already be sure to use a…

view full answer...

Answer 6

If your Thomas Payne recliner has the power recline function, then the 29 volt, #674864 is the correct heating pad replacement. If not, then the Replacement 12 Volt Seat Heating Pad for Thomas Payne RV Theatre Seating #LC38UD is the correct…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Hey Ron, good to hear from you! How long are your current U-Bolts? The U-Bolt Kit #APUBR-8 could potentially work as it has 7" long U-Bolts, but it really boils down to what you currently have. For something longer we have the MORryde U-Bolt Kit…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

It looks like you ordered both from us today to use with your Carrier lower vent assembly. The heat strip will work with the Advent but if I am being perfectly honest a lot of times these mixed brand AC Unit solutions don't work as consistently…

view full answer...

How To Replace The Heating Pad In A Thomas Payne Seismic Recliner

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching