Is Hitch Height of B and W Patriot Slider Hitch a Major Concern When Towing

Updated 05/26/2025 | Published 07/25/2019

Products Featured in This Question

B&W Patriot 5th Wheel Trailer Hitch w/ Slider - Dual Jaw - 18,000 lbs

(776)

$899.00

B&W Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches

(177)

$260.00

Question:

I am new to pulling 5th wheel campers. I really like this hitch but I noticed that it only has 3inch of height adjustment. My truck is a 2016 Ram 2500 and sits pretty high in the back. I havent purchased a trailer yet so I cant see how high or low it will be compared to my truck. How concerned should I be about this? A trailer that I am looking at is shown online with basically the same truck as mine hooked to it and it looks way too high in the front. Would this be more of an adjusting the trailer axles more than a lowering of the hitch issue?

asked by: Jason

Expert Reply:

Normally a great deal of height adjustment is not needed with fifth wheel hitches. There are some really well known hitches that don't offer any adjustment at all. The height range of the B and W Patriot part # BWRVK3270 is 17-19 inches which typically is all that's needed. Also you can adjust the height of the pin box on the trailer for further adjustment so additional height adjustment is available. Since you don't have a trailer yet and the fact that height range is pretty rarely an issue with newer trucks and trailers I wouldn't worry too much about it.

The correct install kit for your 2016 Ram 2500 is the part # BWRVK2602 that you referenced as well.

expert reply by: Jameson C

Billy M.

5/26/2025

I have a Patriot 18k slider can I raise the height I don’t have enough clearance at top of bed & camper if so do have a diagram

Jameson C.

5/26/2025

@BillyM The Patriot Slider hitch does have adjustability built onto the hitch. It can go from 17 to 19 inches. Take the head off of the hitch and look at the arms that hold the head to the base. They are bolted to the hitch on the inside portion of it and can be attached in a couple different bolt hole locations.