Third Brake Light Stop Lamp Isolation Converter Compatible with LED Lights
Question:
Im simply adding a 3rd LED brake light to an enclosed trailer that came with LED brake/ signal lights. Its to my understanding this converter is required to isolate the third LED light from any signal functions. My question is: Will this converter work with the brake/ signal lights being LEDs? In other words, do the LED tail lights create enough electrical draw for the box to accept their input so it can do its thing with regards to the 3rd brake light operating only under braking conditions? Thank you for time.
asked by: Tom
Expert Reply:
To isolate the stop lamp from the turn signal for your third brake light if you have combined functions at your trailer tail light you would need the Pacer Performance 3rd Brake Light Logic Module # PP20-702 for the easiest converter. You won't have any issue with the power draw for this to function correctly.
Products Referenced in This Question
Product Page this Question was Asked From
2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- 7 Round
- Tow Ready
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Vehicle Lights
- Shop: 1141/1156/1003 LED Bulb - Single Contact Bayonet - 180 Degree - 165 Lumens - Warm White - Qty 2
- Video: Breaking Down the Ventline Ventadome Trailer Roof Vent
- Video: In-Depth Review of the Ventline Ventadome Trailer Roof Vent
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Smoke
- Shop: Vent Installation Kit
- Shop: Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" - White - Birch Trim
- Shop: Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White
- Shop: Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" x 14-1/4" - Smoke
- Shop: Replacement Dome Seal for Ventline Ventadome Trailer Roof Vents
- Shop: Truck Bed Mat
- Video: What to Know About the Tail Light Isolating Diodes (Qty 4)
- Video: Setting up the Tail Light Isolating Diodes (Qty 4) on a 2011 Jeep Liberty
- Q&A: Does Tow Bar Diode Kit Allow Running Lights and Stop/Turn Circuits of Towed Vehicle to Operate
- Search Results: e25vr
- Search Results: black armour
- Search Results: ssf~170~40~2
- Search Results: ssr~187~54~1
- Search Results: 20~702
- Search Results: battery boxes
- Search Results: battery isolators
- Q&A: Which Converter Module is Recommended When Adding a 3rd Brake Light to the Rear of the Trailer
- Q&A: How to Wire a Third Brake Light on Trailer
- Q&A: How to Install 3-Wire LED Type Light to 4-Pole Wiring
- Q&A: LED Third Brake Light Bar Option
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: Trailer Wiring Diagrams
- Video: Finding the Right Trailer Wiring Harness
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Accessories and Parts
