Removing Kick Panel of 2014 Jeep Cherokee to Install Brake Controller
Question:
I removed the screw but panel seems very tight. which way do I pull
asked by: Gary T
0
Expert Reply:
Interior panels can fit pretty tight even when the hardware that secures them is removed. You will want to basically pull out and down to get the panel free but you have to be careful not to get too aggressive. The right side should be the easier side to start with.
I have cracked interior panels before from trying to just yank them out so you basically have to proceed with caution and just take it slow as you pry the edges of the panel out.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Brake Controller Wiring Harness Location 2017 Jeep Cherokee
- Q&A: Location of Brake Controller Plug 2019 Jeep Cherokee Limited
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Spec for a 1/2 Stud with Coned Lugs on a 15 in Steel Wheel
- Q&A: How To Get Both A 7-Way And 4-Pin Connector On A 2011 Nissan Frontier
- Q&A: Where Does a Brake Controller Plug In to on a 2016 Jeep Cherokee
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: 2019 Jeep Cherokee Trailhawk Trailer Brake Controller Installation
- Q&A: Brake Controller Install Harness that Fits 2023 Jeep Grand Cherokee L
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
Terry K.
7/8/2020
is the 2017 jeep sport trail done the same way to get the panel off for electric brake harness