How Do RV Step Outriggers Install

Question:

Where do they mount and how?

asked by: Kenny C

Helpful Expert Reply:

Outriggers such as # LC301704 bolt to the sides of steps such as # LC432698. The outriggers will bolt to the RV frame. For hardware to attach the steps to the outriggers use # LC118155-72.

The specific location and orientation of the outriggers depends on the RV/trailer. There isn't one set way they would have to be installed. And some applications do not use the outriggers.

The installation of the steps is as follows:

1. Ensure step is completely back up against the step supports on frame [Angle or Tube].
2. Insert carriage bolts and flange lock nuts. Tighten down only until snug in order to make adjustments.
3. Verify that the step housing is square, level to the outrigger, and plumb to the chassis. Once you have verified this, tighten the carriage bolts down.
4. Attach tech screws through the step supports, 2 (1) each side, to the step supports on the chassis.
5. Attach lag bolt or bolts to floor through the outer end holes in the outrigger.