Wheel Covers Hubcaps Specs:
Features:
Designed for Chevy Workhorse chassis with 22-1/2" x 6-3/4", 8-lug dually wheels with 4 hand holes. These 4 durable stainless steel Wheel Liners add life to your existing wheels. Hardware included.
Installation Notes:
Designed for models with dual rear wheels only
More Information >Videos
for Wheel Well Liner
Help Articles
for Wheel Well Liner
Expert Answers
for Wheel Well Liner
The Gen-Y Weld-On 2" Receiver Tube #325-GH-003 is 2-7/8" wide on the tube and 3-1/2" wide at the collar. The overall length is 12".
view full answer...In almost all cases 3,500 lb axles will all use the same bearings. If your trailer has a Lippert or Dexter 3,500 lb axle then yeah they would be the same. But to be safe it won't hurt to pull them off and get the numbers. If you…
view full answer...For your 2014 Ford F-250/350 Super Duty you will want to use Wheel Masters 4-Hose Inflation Kit part #WM8001. The bend on the Wheel Masters 4-Hose Inflation Kit part #WM8001-135 causes the hoses to be in contact with your rim as soon as it comes…
view full answer...I can absolutely tell you the difference between the two options. The Kwikee 38 Series Electric Step #LC3723383 comes with a control module, which means it will automatically extend. The Kwikee 38 Series Electric Step #LC372338 does not come with…
view full answer...Although we do not have a direct replacement for the Dicor V19582-EJN, the Replacement Wheel Master Lug Nut Cover for Wheel Liner - Qty 1 #WMRMT9061 will fit a 22 millimeter lug nut. From what I have found, the jam nut you are looking for has been…
view full answer...Your travel trailer likely has a regulator with an automatic change over valve built into it. As you probably know, when the first bottle is empty it switches over to the second bottle. The bottle and switch are before the regulator, so only the…
view full answer...For replacing the Drive Head #LC34FR and Idler Head #LC87FR on a Solera Slide Topper you will want to completely remove the slide topper from your RV/Camper. You will need to insert a pin into the end of the tube end cap(see image) to keep the…
view full answer...Your Curt Pop-In Ball for Factory Ford and Ram Underbed Gooseneck Hitches - 2-5/16" Diameter Ball #C60601 lifts the pin when that lever is lifted. Because that lever is broken off you will need to lift that pin and turn it 90…
view full answer...I do have options for you, but the Wheel Masters Inflation Kits are not vehicle specific parts. They are going to depend on the wheel set-up that you have. However, I can provide you with a couple of the most common options we typically see on the…
view full answer...No, the E-Coat is not to be removed from the rotors. The E-coat is a protective coat that will prevent corrosion but it will not cause issues with coating your brake pads or have any negative impact. The Dexter Disc Brake Kit -…
view full answer...As far as a left-threaded or right-threaded cap for your motorhome, right-handed threads run clockwise, and left-handed threads run counterclockwise. The reason for this difference is that some applications of screws can come loose with the motion…
view full answer...The The Brophy Camper Tie Downs #TDSF, are a universal fit kit intended to fit as many trucks as possible. While there is nothing to say that it for sure fits, looking at your pictures it seems likely that it will work for your 1968 Ford F-250…
view full answer...Filter Products (2)