Brake Controller for Ford
Brake controllers with a custom fit wiring harness for your Ford make trailer towing safer and installation easier. We offer high quality controllers in both time-delay and proportional models, from manufacturers such as Tekonsha, Hopkins, Valley, and Draw-Tite. Brake controller wiring adapters are available for most Ford vehicles, allowing for simple plug-and-play installation.
What our customers are saying:
Thanks for the great service and fine products. I received my order on the 3rd business after placing it and that was w/ the standard ground shipping. The hitch went on just great and looks good also. It sure is substantial and heavy duty. I am not quite done w/all of the wiring but I am sure everything will work just fine. Thanks again for the break control directions. Certainly I will recommend your company to anyone I know looking for these type of products. Larry
Larry
Roscommon, MI
Trailer Brake Controller Installation - 2011 Ford Ranger
Today in our 2011 Ford Ranger we are going to be installing the Prodigy P2 Brake controller, part number P90885 in conjunction with the ETBC7 wiring kit for our new simple harness which will be mounted with the no drill bracket from Draw-Tite, part number 18136. To begin our installation we are going to start here at the back of the vehicle. Go ahead and wire up our bracket and start running our new duplex cable to the front of the vehicle. As you can see this vehicle is already equipped with a four pole harness. Before we can install our seven-pole well need to go ahead and attach the mounting bracket. Well use some supplied hardware then once we get all four fasteners in position well go ahead and tighten them down.
Trailer Brake Controller Installation - 2006 Ford Ranger Part 2
This is the second video showing the final steps required to install the Tekonsha Prodigy brake controller on the 2006 Ford Ranger truck. It can sound like a lot of work but finish watching the video, you will see it really is not as hard as it may sound. You will see where the brake controller is actually mounted in the drivers area and how the connections to the battery are made
Trailer Brake Controller Installation - 2006 Ford Ranger
We show you here how to hardwire your vehicle with an electric brake controller. We are using the popular Tekonsha Prodigy and using our Brake Controller 7 and 4 Way Installation Kit, ETBC7, to set this 2006 Ford Ranger up to tow a trailer with electric brakes. Even though the truck is not pre wired to accept a brake controller it can be done allowing you to safely tow campers, utility trailers, horse or livestock trailers and more.
