2004 Dodge Dakota Vehicle Lights

Yes, the 921 LED Bulbs #ARC48FR would be a compatible replacement for a JRP1007B light bulb. With this light being LED it will have a lower wattage and amperage draw for a cooler, brighter light that requires less energy to run.

We do offer teardrop style clearance lights in red, the Pacer Performance Hi-Five Truck Cab Light Kit part #PP20-215 which are sold as a set of five. These lights by law must be installed so that they face the rear of your vehicle. They come with…

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R uses a combination of 16 and 18 gauge wire. It may seem thin but with short distances like with this harness 16 and 18 gauge wires can actually handle a surprising amount of…

I recommend picking up the Durabilt Safety Chain Connectors for 5/8" Chain #DU55QR for use with your 2021 Chevy Silverado 1500. These have a safe Working Load Limit of 18,100 lbs…

The distinction you're referring to is about whether or not your Silverado has running boards or steps that sit under the bed and could block the fitment of a frame mounted camper…

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R will not effect your daytime running lights. This harness just bypasses the power draw from the headlight switch by pulling power directly from the car’s battery, which will…

You are correct the hook ups are for the lights on the Blazer LED Cube Light Kit #BL28VR. The different ratings are for each of the circuits. The lights that come with the kit will fit onto the smaller connections allowing you to connect more…

Congrats on the new truck! To add an in bed 7-way connector to your 2023 Ram 3500, I recommend the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector item #A10-7007. This harness puts a 7-way connector in the bed of your truck and…

Hey Tom so I definitely know what you are asking for but due to the very minimalistic design of the Kuat Transfer part #KU84FR there isn't a great way to add lights to it. But the…

Thanks for the axle information, Mike! Here are the correct parts according to my contact at Curt: - Bearing #02475 and Race #02420 - Bearing #25580 and Race #25520 - Grease Seals #RG06-070

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

The etrailer Trailer Hitch Receiver #e59AR will reduce the ground clearance on your 2013 Subaru Forester some, but it won't make the vehicle sit lower in the back. The only reason…