Custom Fit 2013 Jeep Wrangler Accessories

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

Sorry to hear about your troubles! That is correct, the 12V PWM Filter for RV Backup Camera Systems #VGR64VR will provide a steady current for the camera and will take care of the issues you're having with your Furrion Vision S Wireless RV Backup…

If the base of your marker light, #1A-S-9, is part of the Kaper II Trailer Light #1A-S-100A, then the correct replacement base is the Optronics Rectangular Marker Light, #MC32RB. This marker light comes with a red lens and the replacement red lenses…

The Replacement Pin Sleeve part #RM-A005116 has an inner diameter of 7/8 inches and an outer diameter of 1 inch.

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

It sounds like a bad ground connection. What you will do is disconnect the trailer from the vehicle. Then make sure the ground for the wiring harness #C56049 is attached to a clean and corrosion free bare metal surface. Use a circuit tester like…

You can utilize the crossbar mounting system on your Roadmaster StowMaster Tow Bar #RM-501 as long as you use a Roadmaster Crossbar Style base plate on your 2013 Jeep Wrangler. We have a couple of different options depending on the sub-model of your…

Other than the Tow Bar, you would need the wiring so that the lights on your Wrangler would work in tandem with the lights on the tow vehicle, and the vehicle-specific base plates that would attach to the Wrangler. The base plates provide an…

Yes, we have an extension that you can attach to the Rhino-Rack Batwing Compact Awning part #RR33300 for driver side or part #RR33400 for passenger side, the Extension for Rhino-Rack Sunseeker, Batwing, and Foxwing Awnings (48 Sq Ft) part #RR32111.…

I went out to the warehouse and pulled a similar part, #RM-910030, to take some measurements. The only difference is that the part I measured is a flat piece and does not have that lip at the top. The center holes are exactly the same. I took several…

The Blue Ox Base Plate Kit part #BX1126 that you referenced is the correct fit for your 2013 Jeep Wrangler and also is compatible with the Blue Ox Alexxa tow bar that you have as well. You would not need to take any measurements either.

The front of your Barricade Extreme HD Full Width Front Bumper with LED Fog Lights has D-rings which you can use to connect a tow bar to with the correct size D-ring adapter. For a 1 inch D-ring you'd need the part #RM-035-1 or if you have a 3/4…