2009 Ford Explorer Accessories

2009 Ford Explorer Trailer Hitch

2009 Ford Explorer Trailer Wiring

2009 Ford Explorer Brake Controller

2009 Ford Explorer Front Mount Hitch

2009 Ford Explorer Base Plate for Tow Bar

2009 Ford Explorer Vehicle Tow Bar Brake System

2009 Ford Explorer Vehicle Tow Bar Wiring

2009 Ford Explorer Roof Rack

2009 Ford Explorer Trunk Bike Rack

2009 Ford Explorer Vehicle Cargo Control

2009 Ford Explorer Air Filter

2009 Ford Explorer Exhaust

2009 Ford Explorer Suspension Enhancement

2009 Ford Explorer Transmission Cooler

2009 Ford Explorer Performance Chip

2009 Ford Explorer Interior Lights

2009 Ford Explorer Exterior Lights

2009 Ford Explorer Tire Chains

2009 Ford Explorer Fluid Filters

2009 Ford Explorer Floor Mats

2009 Ford Explorer Tube Steps

2009 Ford Explorer Trim Kits

2009 Ford Explorer Vehicle Covers

2009 Ford Explorer Grille Guard

2009 Ford Explorer Bug Shield

2009 Ford Explorer Side Window Vents

2009 Ford Explorer Mud Flaps

2009 Ford Explorer Lamp Guards

2009 Ford Explorer Vehicle Tent

2009 Ford Explorer Vehicle Seat Covers

2009 Ford Explorer Windshield Wiper Blades

Popular Ford Explorer Accessories

Ford Explorer Cargo Carriers

Ford Explorer Bike Rack

Ford Explorer Weight Distribution

Ford Explorer Ball Mounts

Ford Explorer Cargo Bags

Ford Explorer Locks

Ford Explorer Tow Bar Braking Systems

Ford Explorer Hitch Covers

Ford Explorer Electronics

2009 Ford Explorer Questions and Answers

• Parts Needed to Mount Yakima PowderHound Ski and Snowboard Carrier to 2009 Ford Explorer
  
• To use the Yakima PowderHound on your Explorer, you will need crossbars to provide an attachment point. If you have the factory crossbars that are no larger than 3-7/8 inches wide or 1-1/4 inches tall, the PowderHound will attach directly to them. If you do not have crossbars, you can install them using the Yakima RaiGrab kit, parts # Y00408 and Y00138. You might also be interested in a fairing. For the Ford Explorer, Yakima recommends a 44 inch fairing, part # Y07048.
  view full answer...


• Trailer Hitch Pin Lock for a 2009 Ford Explorer with Little Space to Use a Lock
  
• I have not heard of this exact issue before on any vehicle. Certainly, you can use a hitch pin/lock in any orientation that works for you. The Master Lock EZ Access Lock, # 2854DAT, has a similar design with a swivel head that was specifically designed for hitches that have a hitch pin hole close to the hitch cross tubing.
  view full answer...


• Does the Ford Brake/Tail Light LED Trailer Hitch Cover Plug Into a 4-Way Flat Vehicle Side Connector
  
• The Brake and Tail Light L.E.D. Trailer Hitch Cover, # CR-017F, does come with a 4-Way connector that will plug into a 4-Way flat receptacle on the 2009 Ford Explorer. If your Explorer did not come with a trailer connector you would first need to add one using # 119175KIT. I have included a link to the installation details for the wiring harness. If your Explorer came with a 7-Way trailer connector but no 4-Way connector, you would need to use an adapter like # PK12716, to convert the 7-Way t
  view full answer...


• Can Draw-Tite 4 Pole Hardwire Kit 20251 Be Used on a 2009 Land Rover LR2
  
• Draw-Tite kit part # 20251 cannot be used on vehicles with LED tail lights. I am not sure if the 2009 LR2 uses LED lights or not. I know may Land Rover models do. The recommended kit for a Land Rover LR2 is part # 119176 or part # 11976KIT. These harness parts run a direct power wire to the vehicle battery so they can be used on vehicles incandescent tail lights or LED tail lights.
  view full answer...


• Dimensions of the Highland Semi-Custom All Weather Liner for the 2009 Ford Explorer
  
• The Semi-Custom All Weather Rubber Cargo Mat, # 4401200, measures 54-1/2 inches x 49-1/4 inches. It is designed to be trimmed to fit. It is also available in gray, # 4501200, or black, # 4601200.
  view full answer...