view cartView Cart

CALL NOW - 800-298-8924

Product Experts Available Now!

Free Shipping on Orders Over $99

Only 9 Hours 4 Minutes Remaining




2001 Ford Excursion Accessories

change vehicle




2001 Ford Excursion Questions and Answers


  • Mounting Hole Pattern of Pollak 7-way Trailer Connector # PK12707
  • I've edited a photo for you showing those dimensions. Measured horizontally, the holes are 2-1/4 inches apart, and 1-1/4 inches apart measured vertically.
    view full answer...

  • Front Mounted Receiver Hitch for 2001 Ford Excursion
  • We do indeed have a front mounted receiver that's a fit for the 2001 Excursion, part # 65022. The hitch would install directly to the front of the frame members behind the bumper. Installation involves removing the bumper, and sandwiching the hitch in between the frame members and the bumper as shown in the instructions I've linked. If your Expedition is equipped with the OEM foglights, they'll need to be relocated or removed for the receiver to fit. The Curt # C31014 front mounted receiver...
    view full answer...

  • Roof Rack And Cargo Carrier For 2001 Ford Excursion
  • We do offer a roof rack system that will fit your 2001 Ford Excursion with the factory side rails. I recommend the Yakima roof rack that has 58 inch round crossbars. When ordering this roof rack system you will need to order part # Y00409, part # Y00221, and part # Y00214. We currently do not offer any roof baskets that have open ends as you are describing. The largest roof basket i can recommend is the Surco Safari Rack 5.0 Rooftop Cargo Basket, part # SPS65100-Y400. This basket is...
    view full answer...

  • Timbren Suspension Enhancement For 2001 Ford Excursion
  • The Timbren Suspension Enhancement, part # TFF350SD4, is intended to assist the front suspension you have on your 2001 Ford Excursion. This kit is for 4-wheel vehicles. Suspension enhancement is intended to be used on vehicles with suspension that is in good working condition. It is not intended to be used as a replacement for your suspension. I pulled one of these from our warehouse and took a couple of measurements. The spring measures 3-3/4 inches and the plate it is attached to...
    view full answer...

  • Which Performance Tuner Will Provide More Increased Gas Mileage For 1999 Ford F250/2001 Excursion
  • I spoke with my technical contacts at both Superchips and Edge Performance and have the following information regarding which performance tuner will improve your mileage on both your 1999 Ford F-250 and your 2001 Ford Excursion. There are so many variables that determine gas mileage that results are not vehicle specifically documented because the conditions cannot be duplicated by each individual driver, so both of the manufacturers can only speak of generalities. The Superchips...
    view full answer...

  • Electric Drum Trailer Brakes for a 2004 Pace Trailer with Tandem 3500 Pound Axles
  • One way that you might be able to determine if you have self-adjusting or regular brakes. On self-adjusting brakes like # 23-468 as an example there is a cable that attaches one shoe to the other. You can see it in the picture on the product page. A manual adjust brake like # TRBK10E01 that you have referenced does not have this cable. If you want regular manually adjust 10 x 2-1/4 brakes you can use # TRBK10E01 for the left side and # TRBK10E02. For self-adjusting 10 x 2-1/4 brakes...
    view full answer...

  • How to Properly Snap the Bracket Covers on the Thule MOAB Cover
  • I think I know what is going on with your Thule M.O.A.B. Roof Top Cargo Carrier # TH690. I went out and talked to one of our installers and he said he had the same problem you are describing when he had the mounting points too close to the thicker bars that run from front to back on the cargo basket. If you space the mounting brackets a little farther away from those bars the problem you are experiencing should go away. If the mounting brackets are too close to those bars the lock covers...
    view full answer...

  • Roof Mount Cargo Basket Recommendations for a 2001 Ford Excursion with Factory Roof Rack
  • I did some research and found that the Thule MOAB, # TH690, is a direct fit to the factory installed crossbars on your 2001 Ford Excursion. The Yakima baskets are not listed as a fit and to determine if the Rola basket will fit there are some crossbar measurements you will need to take. If the cross bars are 3-1/4 inches or less wide and 1-1/4 inches or less tall then the mounting hardware on the Rola basket, # 59504, will fit. But, you also have to measure the center to center distance...
    view full answer...

  • How Does a Wheel or Footplate Install in the Fulton F2 Adjustable A-Frame Trailer Jack
  • The Wide-Track Wheel Assembly, # F500266, footplate, # F500267, or twin-track wheel, # F500265 fit a specific jack, the Fulton F2 Adjustable A-Frame Jack, # F1413250334. The assembly slides up into the bottom of the jack tube and the pin goes through the holes. There is no cutting or welding required. I made a video showing the installation of a wheel in the jack for you. If you are trying to install the wheel on a different jack, it will not be compatible. If it is a different jack...
    view full answer...

  • Weight Distribution for 2001 Ford Excursion Pulling a 7500lb Holiday Rambler Trailer
  • An air bag or helper spring set-up is most effective for dealing with weight carried in or on the vehicle itself. A properly sized and adjusted weight distribution system will preform several tasks. It will eliminate the sag experienced when a trailer is hitched up, it can reduce or eliminate trailer sway and it can also improve braking performance and and steering response. A weight distribution system accomplishes this by using leverage to transfer a portion of the trailer tongue weight...
    view full answer...

  • Timbren Suspension Enhancement for the Front and Rear of a 2001 Ford Excursion 4x4 7.3L Diesel
  • The Timbren Rear Suspension Enhancement System, item # TFREXC4, is only the rear kit for your 2001 Excursion 4x4. For the front suspension you will need the Timbren Front Suspension Enhancement System, item # TFF350SD4. These front suspension helpers will definitely help with the large 7.3L motor in your Excursion. Both of these kits will require the removal of the original bump stop but will not require shock or spring removal and do not require any modifications to the original...
    view full answer...










Stay Connected


Subscribe to email newsletter

Email  

privacy - we don't send unsolicited email





Free Shipping on Orders Over $99

Only 9 Hours 4 Minutes Remaining


etrailer.com reviewsetrailer.com reviews

All images, layout and content copyright etrailer.com